I need some help figuring out how to wire something up to my Rx
So this may sound kinda dumb but I would like to wire something in a way where it plugs into the Rx like a servo but Activates, either on or off, from my Tx. Now I tried wiring a positive wire and then the signal wire in and realized that wouldn't work because the signal wire sends just that... a signal not pure voltage. I tried this once but I still could bbe wrong
Essentially I would like to wire a motor to my Rx, a micro motor, to activate when I toggle a switch on and off. If there is a simple way/product that I could do this to please help me out.
Frankly I just need to turn power 100% on power 100% off.
This can solve your problem:
How to use it:
Its good up to 30V and 10A. JOMAR also have something equivalent:
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Please help! New to Nimh, can't figure out how to connect receiver pack to Elysium ch||The knifes edge||Batteries and Chargers||4||May 08, 2012 02:45 AM|
|Help!||Need help setting up my tx/rx||bnb2fly||Beginner Training Area (Heli-Electric)||2||Mar 04, 2012 08:23 PM|
|Help!||i just got my fpv stuff and i can't figure out how to:||flohio117||FPV Talk||10||Mar 02, 2012 02:15 PM|
|Discussion||need help figuring out what battery to use to get max fly time||aussieman||Batteries and Chargers||2||Feb 10, 2012 06:05 PM|
|Discussion||Programming my ECO 6-10 Cannot figure out how to save||kushal_22||Batteries and Chargers||0||Nov 21, 2011 05:38 PM|