New Products Flash Sale
Thread Tools
Old Aug 13, 2012, 12:14 PM
Buffythesaint is offline
Find More Posts by Buffythesaint
Registered User
I had the SpyHawk out this morning for a test flight. I'm getting some poor video but I think it's a mismatch in polorization. I tried the pre-amp but it made it worse. The problem with the pre-amp is, if you get a poor signal, it will amplify the interference. I'll try again when I have a cp antenna on the plane. I have the vtx out of the spyhawk already. I'll add an extension and then a female sma adaptor. I'll post pics after completion.

Here is an unedited video, of a flight this morning, I recorded with my GS DVR.

SpyHawk CP antenna test (4 min 25 sec)
Sign up now
to remove ads between posts
Old Aug 13, 2012, 05:01 PM
Buffythesaint is offline
Find More Posts by Buffythesaint
Registered User
I was able to remove the vtx from the SpyHawk. Make sure you take some pics and mark each wire where it came from. Much easier to reassemble. I removed the stock cable/antenna from the vtx and added an RG174 extension with a sma female on the end. I just ran the cable forward and up onto a hole I made. It came out very clean looking.

Here is a test video after both CP antennas have been installed. I did not try the pre-amp yet. The results were great! I had the tx pointed down our runnway the whole time.

SpyHawk CP antenna test #2 (3 min 23 sec)
Last edited by Buffythesaint; Aug 13, 2012 at 08:04 PM.
Old Aug 14, 2012, 11:54 AM
alexecheverria is offline
Find More Posts by alexecheverria
Registered User

video goggles


Which video glasses are suitable for this TX? I found one that is around $100 at chinavasion.com and wonder if it would work. Thanks.
Old Aug 14, 2012, 01:13 PM
Buffythesaint is offline
Find More Posts by Buffythesaint
Registered User
Quote:
Originally Posted by alexecheverria View Post
Which video glasses are suitable for this TX? I found one that is around $100 at chinavasion.com and wonder if it would work. Thanks.
It will depend if you have a 3.5mm plug, with the googles, to plug into the tx. The tx has video only and only requires a two pin 3.5mm jack, ground and video. I lucked out because I had a Lawmate vrx cable that fit into the tx jack. The cable is a three pin type, video on the tip, audio in the middle and ground closest to the rubber. I had to use the audio channel(middle) to get the video to work, therefore a two pin adapter would work. I'll look for one myself as I want to make a shorter cable to plug into. Do some more research on the specs of the googles and see exactly what they come with. Hate to see you get them and they don't work right away. Hope this helps.
Old Aug 15, 2012, 01:43 PM
Buffythesaint is offline
Find More Posts by Buffythesaint
Registered User
Quote:
Originally Posted by alexecheverria View Post
Which video glasses are suitable for this TX? I found one that is around $100 at chinavasion.com and wonder if it would work. Thanks.
Can you post a link to the googles you are talking about? I'll take a look at them and see what they come with.

Here is a link to the Lawmate av cable that I use to plug into the Hubsan tx. I use the audio channel(white RCA plug) on the lawmate cable and plug it into the video in on the glasses.

http://www.readymaderc.com/store/ind...roducts_id=755
Old Aug 19, 2012, 12:13 PM
Buffythesaint is offline
Find More Posts by Buffythesaint
Registered User
Does anyone know what the exact video frequency number is for the SpyHawk? I sent an e-mail to Hubsan but no response yet.
Old Aug 24, 2012, 03:42 AM
alexvarlet is offline
Find More Posts by alexvarlet
Registered User
Hi Brian,

You can select the frequency with 5Mhz increment from 5710Mhz to 5920Mhz included...
Old Aug 25, 2012, 10:21 PM
Buffythesaint is offline
Find More Posts by Buffythesaint
Registered User
Quote:
Originally Posted by alexvarlet View Post
Hi Brian,

You can select the frequency with 5Mhz increment from 5710Mhz to 5920Mhz included...
Doh!! I should of seen that in the menu, Thanks.
Old Sep 04, 2012, 06:53 AM
alexvarlet is offline
Find More Posts by alexvarlet
Registered User
Hi Brian,

Anything new on your testing?
Old Sep 09, 2012, 01:17 AM
Maseo54 is offline
Find More Posts by Maseo54
Registered User
Maseo54's Avatar
How much would you charge to set up my unit like that?
Old Sep 15, 2012, 04:08 PM
Buffythesaint is offline
Find More Posts by Buffythesaint
Registered User
Quote:
Originally Posted by alexvarlet View Post
Hi Brian,

Anything new on your testing?
Alex, I haven't done any RC in the last few weeks. Before that I was flying my SkyWalker. Usually the winds die down in the evening but its been very windy all nite long lately. The Spyhawk likes calmer nights.

Quote:
Originally Posted by Maseo54 View Post
How much would you charge to set up my unit like that?
Sorry, but I'm not interested in modding the SpyHawk for others. If you have a good soldering iron and some solder skills, this mod is very easy. The CP antennas were from ReadyMadeRC so you just need to add the antenna extensions and sma fittings.
Old Oct 09, 2012, 03:05 PM
juerwotow is offline
Find More Posts by juerwotow
Registered User
juerwotow's Avatar
Hello all!
I am very interested in this model, can you tell me if does it work? What about the new version? is it better? can you post your impresions? and when it is windy? does it manage with the wind?
Thank you!!
Old Oct 09, 2012, 05:40 PM
rotagen is offline
Find More Posts by rotagen
Scratch building addict
rotagen's Avatar
Smart product idea. Having the LCD on the Tx makes so much sense. And the field is more confusing than ever. I'm tempted, but I want to hear a lot more info on the range and a lot more first hand experience. I'm waiting for the micro kits to get better range and reliability since all my planes are relatively small.

Good that RCmodelreviews.com covered it though. This guy is always spot-on in my experience.

Hmmm having watched the review, apparently you cannot move the FPV guts to another airframe? NOT good.

Seems to me the stuff from FPVhobby.com is at least as good or better and I don't need another cheap Tx, just a smallish LCD from ebay for cheap.

But I haven't seen a 5.8 micro system that has any decent range at all, I want at least 1.5 miles if I'm gonna get interested ... just sayin'
Last edited by rotagen; Oct 09, 2012 at 05:51 PM.
Old Oct 19, 2012, 11:36 AM
juerwotow is offline
Find More Posts by juerwotow
Registered User
juerwotow's Avatar
A "brico" to get the CG in its place and to get double time flying...check and give you opinion.
greetings
Old Oct 20, 2012, 11:30 AM
juerwotow is offline
Find More Posts by juerwotow
Registered User
juerwotow's Avatar
Helo again, a question, do you put any reinforcement to the lens of the camera? to avoid the impact in the landings? or it is resistant?
Thank you!!


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion 60C Gens Ace batteries now in stock Shortman Batteries and Chargers 9 Oct 19, 2012 05:34 AM
New Product Hitec Waterproof Servos now in stock! ServoCity ServoCity.com 0 Apr 09, 2012 04:34 PM
Alert HK-5320 back in stock now! nemoskull Scratchbuilt Indoor and Micro Models 18 Mar 19, 2012 09:55 PM
New Product Hitec Eclipse 7 Pro (2.4Ghz) now in stock! ServoCity ServoCity.com 0 Feb 23, 2012 10:22 AM