FPV Project(s) - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by LittleG, who may elect to delete unwanted replies.
May 01, 2012, 02:04 PM
Registered User
LittleG's Avatar

FPV Project(s)

FPV reference:

Building a cloverleaf antenna

FPV Backpack Ground station 1

FPV Backpack Ground station 2

Antennas 101 - Polarization, Diversity & Gain Patterns (27 min 56 sec)

How to install wire mesh tutorial video
Putting wire mash guard on a servo lead (5 min 34 sec)

My equipement from Range Video:

KX151 camera
900MHz , 500 mW transmitter (adjustable microphone gain, automatic Li-poly battery cut off to prevent battery damage)
Standard receiver
0.9GHz 8dBi Patch receiver antenna

Components from ReadyMadeRC:
RMRC-PICO-WIDE 12V (6-24V) Ultra Compact Wide Angle NTSC
Skylark Trace OSD III
Camera Cable (3-Wire Super Compact)
Skylark USB Update Cable for Tiny and Trace OSD (SL-II-USB)
16mm OD Ferrite Torroid for RF Noise Suppression (16MMTORROID)

SkyLark Trace III OSD diagram

Configuring the SkyLark Trace III OSD:
-After downloading the Configure Tools V3 software from http://www.skylarkfpv.com/en/down.php,
-Software and required drivers will be installed automatically.
-Once the software is installed, plug in the Skylark Trace III OSD via the required USB cable. (The computer should automatically detect the OSD board.)
-Set the Port Setting on the PC to COM2
-Launch the software, and change the OSD settings according to your needs.
-After you have selected the desired setting, click on the SET button. This configures the OSD.

SkyLark Thread Link
Last edited by LittleG; Mar 24, 2015 at 05:12 PM.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Wanted Ideas for my fpv project irun4fundotca FPV Equipment (FS/W) 0 Mar 12, 2012 08:32 AM
Build Log IBCrazy's Vampire FPV project IBCrazy FPV Talk 28 Mar 05, 2010 05:06 PM
Yippee! My new FPV project, FPV shockflyer AndrésMtnez FPV Talk 9 Feb 26, 2008 02:39 PM