Qsc 100! - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by RWCLOUD, who may elect to delete unwanted replies.
Apr 24, 2012, 05:05 AM
Registered User
RWCLOUD's Avatar
Build Log

Qsc 100!

Dennis and I decided that we wanted a "Beater" type glider that was fairly inexpensive, something like my QSC 32 inch 3 panel poly, but bigger so that it could be winch launched.

!00 inches would work out well. 4 , 24 inch panels plus 2 inch tips would give us 100 inches. Why 24 inch panels? The foam comes in 24 X 96 inch sheets. I decided on AG 24,25,26 airfoils going on what is recommend by the Charles River Radio Controllers web site. And that the wings would have 1/8 X1/2 inch wooden spars. Also the glass would be attached with Minwax Polycrilic rather then vacuum bagging.

The fuse pod would be from 1/8 inch lite ply and the boom was to be a golf club shaft.

The tails are just smaller version of the wings, but have .060 carbon rods for spars. The rudder also has a balsa spar that is the front half of the hinge line.

The V mount is made of aluminum , the first one is of .045, but is serious overkill, next will be redesigned and of .025.

The wing will be 3 piece, with 1/4 inch plate 6061 T6 Aluminum cut into a chevron shape. My 2 Meter has 1/8 inch plates and it can take a full pedal launch, so these should be OK

I've been texting Dennis pictures as progress is made . I'll try posting them here. The are not in any special order And the build sequence may seem a little different, but this is what works for me.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Build Log QSC 32 inch 3 panel poly with drawings RWCLOUD Hand Launch 91 Nov 25, 2011 05:08 AM