Wiring harness for Sony 1/3 CCD Board Cams. Anyone have DigiKey or Mouser Part #'s? - RC Groups
Thread Tools
Apr 22, 2012, 07:29 AM
Full-Blown RC Junkie
Snowboard_Nut's Avatar

Wiring harness for Sony 1/3 CCD Board Cams. Anyone have DigiKey or Mouser Part #'s?

I have read hints that the connector for video/pwr on the 650tvl Effio version is a Molex .125 spaced 3 pin plug. I searched Digikey and Mouser and can't find anything close. I've seen this same connector used on video card cooling fans as well. Does anyone have a part number for the 3 pin connector with bare lead wires? I assume all the Sony Board Cams use this same connector, although with different pin counts.... Any help is appreciated greatly.
Sign up now
to remove ads between posts
Apr 22, 2012, 03:16 PM
Full-Blown RC Junkie
Snowboard_Nut's Avatar
63 views, and not a single reply. I thought this was going to be easy, apparently not so. I guess I could solder, but the pins on the board are pretty darn small, and I would like to keep the unit unpluggable if need be. My goal is to sit the 4-way joystick control cable for the cams OSD off to the side and only use it when a cam adjustment is needed, then use a lightweight 3 pin lead from cam to vTx during flight. Surely someone with the heavy 4-way joystick control unit for the OSD has done this same thing?

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion SONY 1/3" CCD 480 TVL Cam for only $40 EyeFlyPlanes FPV Talk 66 Jan 23, 2015 08:27 PM
Help! 600TVL SONY SUPER HAD CCD D-WDR Color Board Camera OSD Menu 2.8mm lens not working bighead93 FPV Equipment 18 Jan 10, 2015 11:01 PM
Discussion Ebay - 700TVL 1/3" CCD II cam for 39$ shipped - anyone tested these ? i3dm FPV Talk 2 Mar 22, 2012 04:38 AM
Sold 900MHZ 100mW Tx/Rx & 1/3-inch Sony CCD Camera NTSC daskip87 FPV Equipment (FS/W) 2 Sep 16, 2011 09:49 AM
Discussion Anyone have an old CCD or CMOS Cam?? qualcity Aerial Photography 0 Apr 03, 2006 02:06 AM