GF3 and naza
well, panasonic GF3 is getting a workout on my f550 with naza. It is a great camera and great value. with firmware hack, the video mode is as good as anything available. its four third size sensor only 22% smaller than nex-5n sensor, and used in many dslr.
anyway, I was testing my F550 with roll stabilization and tilt connected to the naza reg (roll servo had its own reg) and I got hit by glitches.
this basically reaffirm that you should never power the servo off regs that your multicopter depends on. lol. I did manage to land, but I was very nervous and I made record controlled descent. 8" props at 2.6kgm hexa load is still usable, but near the limit. I am waiting on the 9x45 from gemfans.
anyhow, here is the video.
update on 4/25/12
well: I finally tracked down this issue, and it was motor to esc connection. I swapped the esc out, and it is no longer an issue. I've tested that esc on ground, and it still works, so I am assuming connector issue.
Last edited by askman; May 02, 2012 at 09:10 PM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||DJI Naza FC - First Page Has Links and Tips||Tahoe Ed||Multirotor Drone Electronics||22272||Dec 08, 2016 06:54 PM|
|Build Log||DJI F550 NAZA ARF COMPLETE BUILD and DJI NAZA ASSISTANT w/ TX CALIBRATION >VIDEOS<||patrick21x||Multirotor Drone Talk||11||Nov 30, 2012 07:13 PM|
|Discussion||DJI F450 NAZA kit vs Witespy VC450 with NAZA kit||MC21||Multirotor Drone Talk||5||May 16, 2012 02:16 PM|
|Discussion||Dji naza! Combo!||papex||Hot Online Deals||9||Dec 09, 2011 01:21 PM|