Thread Tools
Old Apr 14, 2012, 06:59 AM
boggit is offline
Find More Posts by boggit
Registered User
Question

Help! Help! Help!


I have a Double Horse 9100. A couple of weeks ago the body started spinning in the air, the trim control did nothing. So far, I cannot get to the bottom of the problem!

These are the parts I have replaced:

1) Main Motor
2) Tail Motor
3) Battery
4) PCB Board
5) The TX

I'm about ready to bin the damn thing, has ANYBODY got ANY idea what is going wrong? This is costing a fortune....

Don
Sign up now
to remove ads between posts
Old Apr 14, 2012, 08:00 AM
jombo is offline
Find More Posts by jombo
Bad News Everyone
jombo's Avatar
yep , the motors are bad
Old Apr 14, 2012, 08:45 AM
boggit is offline
Find More Posts by boggit
Registered User
What? Both of them?

Just went and tried it again, and found if I throttle up to 1/2 or above it stabilizes....So does that mean it is still one or both of the motors?

Thanks for the heads up!

Don
Old Apr 14, 2012, 10:43 AM
jombo is offline
Find More Posts by jombo
Bad News Everyone
jombo's Avatar
usually when it spins with the main blades its the tail motor , but i never heard the tail motor spinning the heli the opposite way , its just not powerful enough. the other is if the tail motor is going then you will see it spin alot faster on the ground as the pitch of the main blades are too strong for the tail motor to catch up .
it could be anything really with these small 3 channel helis, it could be a pinched wire going to the tail and not getting enough power to it , it could be a bad motor , maybe even a bad solder joint . this is why brushless is so much better
Old Apr 14, 2012, 05:11 PM
J_skaggs is offline
Find More Posts by J_skaggs
Registered User
Buy a DH9116 and use the DH9100 for parts for the 9116.
Old Apr 19, 2012, 09:22 AM
boggit is offline
Find More Posts by boggit
Registered User
I have just replaced BOTH the motors (main and tail), and it is EXACTLY the same.

I admit defeat.......The cost of replacing the parts have come to more than just buying another DH9100.

So, a word of warning if you are thinking of buying a Double Horse 9100, if the sucker starts to spin, with the trim having no effect, bin it and buy another one....It's cheaper!

Don
Old Apr 21, 2012, 07:56 AM
boggit is offline
Find More Posts by boggit
Registered User
I have now purchased another DH9100 brand new, for less than the cost of 2 PCB boards.

Don


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Help help help Stormchase Foamies (Kits) 25 Mar 11, 2012 07:21 PM
Discussion Help I can't find any info on this engine anywhere can anyone help? wet banshee Engines 6 Mar 11, 2012 10:11 AM
Help! help help please rickstringer Electric Plane Talk 3 Mar 02, 2012 11:48 PM
Discussion Help Help Help Have to order stuff tonight PetroMonkey FPV Talk 12 Dec 05, 2011 08:51 PM