Thread Tools
Old Mar 28, 2012, 06:29 AM
easystarfpv4 is offline
Find More Posts by easystarfpv4
Suspended Account
Question

Does Easystar Elevator Section Need to be Glued on?


As I was putting my easystar together, I noticed that the Elevator section came with a ready to stick on surface, but after sticking it on the base of the fuselage, it just doesn't have a solid feeling of being stuck to the fuselage. Was wondering what others may have done when putting their kit together? Was thinking of putting some glue there to ensure that the part doesn't separate during flight. Any tips to what others may have done would be highly appreciated.
Last edited by easystarfpv4; Mar 28, 2012 at 06:36 AM.
Sign up now
to remove ads between posts
Old Mar 28, 2012, 07:00 AM
Lancer31 is offline
Find More Posts by Lancer31
Registered User

Check the instructions


Instruction 6, in my manual says to make sure everything is lined up straight & true, and then to glue it with Cyanoacrylate cement. They recommend using an accelerator with the cya. Good luck with your EZ*!
Old Mar 28, 2012, 11:13 AM
rcshirt is offline
Find More Posts by rcshirt
miniture aircraft pilot
rcshirt's Avatar
if in doubt, i would glue it. even some planes that bolt on the tail that are arfs should be glued... thinking nexstars...


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Need You Feedback: Sailplane Section on the Esprit Model Web Site Esprit Model Electric Sailplanes 2 Apr 23, 2012 09:05 PM
Discussion What should Initial elevator travel be on a Radian? Riodiler1 Thermal 1 Mar 20, 2012 05:25 AM
Help! Does Optic 6 Sport need to be updated jlremr Hitec/Multiplex USA 3 Jan 11, 2012 12:43 PM