Thread Tools
Old Mar 19, 2012, 01:17 AM
old4570 is offline
Find More Posts by old4570
Registered User
Discussion

My 450 motor blew up - well not quite


Actually what happen was I bumped the throttle and bang the shaft snapped where the C-clip goes [ guess its a weak spot ] when the motor suddenly powered up (must be a good motor)

Motor was a 2832 , and no 2832 shafts to be found on Ebay ..

Took a punt on some 2830 shafts that were about 2mm shorter .

Long story short , shafts came today , took all of 5 minutes to have the motor back together again

Moral of the story , use the throttle lock out ...
Sign up now
to remove ads between posts
Old Mar 19, 2012, 12:48 PM
1Man1Mountain is offline
Find More Posts by 1Man1Mountain
Never Go Full Retard
1Man1Mountain's Avatar
might be a fluke but i would not trust a morot like that.

now if you go from normal to idle up (on my heli 50-60% throttle to 80) will that effect the motor? it definetely should not.
Old Mar 19, 2012, 05:06 PM
old4570 is offline
Find More Posts by old4570
Registered User

Naa


I bumped the throttle from 0 or standing start to full [ obviously no soft start ] , and full throttle is 80% on mine .. [ set at the transmitter ]

So 0 to 80% with everything stationary ... , the main gear [ main cog ] took a beating [ but I had a spare ] ....

Motor ran fine , this was 100% user error ...


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Lost, well not quite California Condor Aerial Photography 67 Jul 23, 2009 01:29 AM
Discussion Magic Carpet Ride........well not quite....haha randall1959 Aerial Photography 3 Sep 21, 2007 09:44 PM
Blew up my motor xenne Kontronik 1 Aug 26, 2005 11:17 PM
Aerohawk maiden flight, well not quite peterbennett26 Micro Helis 13 Jun 24, 2004 05:56 PM
What not to do with a Maha charger or How I blew up a LiPoly Inari Parkflyers 22 Jan 01, 2004 07:27 PM