Help finding part for TR-V7 1:16 Drivft Car
I own this car
and broke this part
It is not in stock as you can see,
Where can I buy a replacment ?
Thanks for helping bring my car to the road
I have an easy way to make proper parts if you have a few small hand tools, some brass tubing and a little patience.
This piece is called a dogbone. RC18T dogbones are a little too long and RC18R dogbones are a little too short, but if you can make one the correct length you will have an easy replacement part. I started with the RC18T dogbone, cut a few mm out of the center with a hobby knife. Then I found some brass tubing that fit tight over the cut digbone at my hobby shop. Drop some CA glue on the shaft and slide a piece of the tubing over it. If you have the correct size tube it will be as strong or stronger than before you cut it, and replacement dogbones are easy to find.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||WTS/WTT 1/10 Slash Roller for 1/16 slash or rally||zeroack||Cars - Trucks and Parts (FS/W)||3||Jun 09, 2012 05:14 PM|
|Help!||Help finding the source for video interference||sharonx||FPV Talk||20||Mar 21, 2012 01:39 PM|
|Discussion||Help wiring BB gun to 1/16 tank||roman1613||RC Tanks||5||Mar 05, 2012 01:19 AM|
|Wanted||RC Car 1/36 , 1/24, 1/16, 1/12 , 1/10||thesoulcrusher||Cars - Cars and Parts (FS/W)||5||Feb 20, 2012 08:41 PM|
|Discussion||Help finding part for S031G||the1inblue||Coaxial Helicopters||14||Dec 27, 2011 08:55 PM|