Thread Tools
Old Mar 01, 2012, 08:07 PM
rkenosha is offline
Find More Posts by rkenosha
Registered User
Discussion

What to look for when setting main gain?


Hi again, What are the charateristics that I would look for knowing that I have dialed in the main and correct main gain.

Thanks Roman
Sign up now
to remove ads between posts
Old Mar 01, 2012, 08:32 PM
Adidas4275 is offline
Find More Posts by Adidas4275
manual flying apologist
Adidas4275's Avatar
too low and control will be mushy.... to high and when you bang the sticks around it occilates.

i always keep increasing until it occilates and then back in down in small increments until it stops.

that way you have the most control... also do testing in different situations.... windy v calm.... heavy v light load.

generally a heavy load = lower gain...... generally.
Old Mar 01, 2012, 08:40 PM
JZSlenker is offline
Find More Posts by JZSlenker
JZSlenker's Avatar
I typically listen to the prop sound when adjusting my gain. The oscillations that occur when the gain is too high is accompanied by a pulsing sound instead of the consistent swarm of bees sound.
Old Mar 03, 2012, 08:52 AM
ed.ge is offline
Find More Posts by ed.ge
Registered User
I am using a gain some steps below oscillations which is quite slow in response & great for AP!


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Careful! SOLVED: Setting EPA for AL on 3 way switch - 0 gain switch of death tahoelight Aerial Photography 5 Oct 25, 2011 10:41 PM
Discussion What to look for when choosing a brushless outrunner motor for an electric plane twoshadetod The Builders Workshop 14 Oct 24, 2010 08:25 AM
Discussion Newbie Question :- What to look for when setting CoG of a 3D plane? fooyukvoon 3D Flying 6 May 02, 2010 06:55 PM
Question What to look for when buying used mygt1 Off-road Cars 4 Aug 11, 2008 06:34 PM
What factors affect GAIN Setting (on GY240) OzzieFlyer Micro Helis 9 Nov 17, 2004 12:40 PM