|
|
|
|
Thread OP
|
Question
Trimming Plastic - What Dremel Cutting Wheel
I've got to trim a piece of plastic off a Walkera plastic canopy. My plan was to using painters tape as a guide and to prevent scratching the plastic. I've got a Dremel but just not sure which cutting tool to use. Any suggestions???
|
|
|
|
|
|
|
|
|
|
|
I always use this one: http://www.dremel.com/en-us/Accessor...l.aspx?pid=426
The sanding drum http://www.dremel.com/en-us/Accessor...l.aspx?pid=407 is nice for cleaning up afterwards. If it is only thin plastic, the curved scissors are better. http://www3.towerhobbies.com/cgi-bin...&I=LXEVT3&P=ML Lars |
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Similar Threads | |||||
| Category | Thread | Thread Starter | Forum | Replies | Last Post |
| Discussion | Detailing Plastic wheel hubs | ryokox3 | The Builders Workshop | 8 | Feb 17, 2012 06:56 PM |
| Help! | paris v4 board trimming led what voltage | rcta15 | Multirotor Drone Talk | 0 | Nov 21, 2011 11:32 AM |
| Video | Dangerous!...Kevlar cutting with olfa wheel in dremel | jirvin_4505 | Sailplane Talk | 6 | Jan 11, 2008 11:11 PM |
| FS-Plastic HOB Wheel Pants & SA Balsa Wheel Pants | Billy Haynes | Aircraft - Electric - Airplanes (FS/W) | 3 | Dec 31, 2003 11:28 PM | |
| Dremel bit or other for cutting CF plate? | JoeR | Electric Power Systems | 3 | May 28, 2002 09:20 AM | |