Thread Tools
Mar 01, 2012, 02:04 PM
Registered User
Help!

Help! How do you solder these motor wires??


I am replacing all my 6 motors, and when I remove the isolation from each wire, there is only cobber wire directly from the motor ?



Not so easy to see on the picture maybe, but the wire is like a regular Transformator wire.
I have tried to scratch away the isolation part, but the solder will not stay on the wire part

How can I solder this ??

need help right now.

thank you
Sign up now
to remove ads between posts
Mar 01, 2012, 02:06 PM
Registered User
AlPackin's Avatar
clean the enamel off with fine sand paper
Mar 01, 2012, 02:15 PM
Quad lover.
chaosdestro0's Avatar
Put some flux on it.
Mar 01, 2012, 02:24 PM
Registered User
2 great tips.. I will try
Mar 01, 2012, 02:51 PM
Registered User
Flux won't work if the enamel is still present. Your best bet is to sand it off as already mentioned, or use a knife and very carefully scrape it off without damaging the wire. Also be sure to get all of it, and not just one side. It can be tricky but it's possible.
Mar 01, 2012, 04:05 PM
Registered User
Quote:
Originally Posted by Saneless
Flux won't work if the enamel is still present. Your best bet is to sand it off as already mentioned, or use a knife and very carefully scrape it off without damaging the wire. Also be sure to get all of it, and not just one side. It can be tricky but it's possible.
It was very tricky... but indeed possible !
Finnish soldering all my 6 motors now.

Thank god I did not had to sand every wire..


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question Do you know how old these cars are? sparkles46 Car Talk 2 Jan 03, 2012 01:39 AM
Help! How do you solder conectors for genius batteries? Hot_Wheels Micro Helis 4 Nov 15, 2011 08:32 AM
Discussion How do you test your solder job? stockman20 Batteries and Chargers 7 Oct 07, 2011 01:34 PM
Discussion Solding two wires - how do you join them pre-solder? infopimp Batteries and Chargers 14 Jan 31, 2007 04:01 PM
How do you get solder to stick to BL wires? randall1959 Electric Plane Talk 9 Oct 17, 2005 11:04 AM