Trim is trim. It adjusts your control surfaces for straight and level flight. I adjust using the trim switches on the radio instead.
low rate % is the percentage of high rate that that low rate is limited to. If high rate elvator, for example, is set to 40 degrees, and you want 20 degree max deflection on low rates, set the % to 50.
Current value is the output value of the channel, based on current switch and stick position.
Play around with it, you'll figure it out.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||How do you set up your plane?||Kiku0||Sailplane Talk||1||Feb 06, 2012 11:08 PM|
|Help!||How do I set up flaperons on my Slider for a Futaba 10-CAP ?||OzparkPilot||Radios||5||Aug 24, 2011 02:49 AM|
|Discussion||How do you assign idle up on DX6?||Mayday~Mayday||Radios||3||Jul 20, 2011 11:55 PM|
|Discussion||How do you set up for "crow/spoilers/reflex"||sa-woody||Electric Sailplanes||3||Jun 21, 2011 07:03 PM|
|Discussion||How do you pack up your wing on a commercial flight?||PnoT||Flying Wings||5||May 07, 2011 04:30 AM|