Finally got back to the P-51 (Durafly) - RC Groups
Thread Tools
This thread is privately moderated by alpinemike, who may elect to delete unwanted replies.
Feb 18, 2012, 03:28 AM
Finally made a maiden flight!
alpinemike's Avatar

Finally got back to the P-51 (Durafly)

shot two coats primer onto the wing tonight. It's not a bad start. Next I'll attempt to carefully etch the few panel lines into the new section and clean up any that were buried under the putty. Finally, I think 320-400 grit and one more primer coat. Then prep for a finish color...

I know it sounds like allot. But, ain't nothing compared to plastic modeling!!! Also, I'll fly this model in "pre-loss condition" or better so help Me gawd!!! After I maiden, I may let My self slouch a bit.

I scheming on an complete repaint... Not sure yet... stay tuned.
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold TX LPU: 1100mm Durafly P-51 Receiver Ready: Flaps, retracts, lights! Roswalt Aircraft - Electric - Airplanes (FS/W) 13 Jan 06, 2012 04:26 PM