New Products Flash Sale
Thread Tools
Old Feb 15, 2012, 11:16 AM
Frazz is offline
Find More Posts by Frazz
Registered User
Discussion

Nunchuck stand alone TX


Hi, guys.
I build this arduino super simple nunchuck r/c stand alone TX compatibile with futaba modules and based on Flytron's Lay-Z open source project.
I made it with an arduino nano , a case and some junk that i had at home.
It works fine with all the Futaba compatible module that I have except Spektrum. The strange thing is that module works if I use it on my 9c and I send the PPM signal by the trainer port
What do you think? Melih from Flytron says that probably depends on the channel count because spektrum module accepts only and entirely 8ch. I tried to increase it on the code without success...
sandro

http://www.flytron.com/pdf/layz_nunchuck_rc.zip
http://www.flytron.com/open-source-h...lus-board.html
Sign up now
to remove ads between posts
Old Feb 20, 2012, 06:42 AM
yurip is offline
Find More Posts by yurip
Registered User
Futaba transmitters in PPM mode only have 8 channels. Spectrum modules can be understood 6,7,8 and 9 channels, look in the thread https://www.rcgroups.com/forums/show...1147689&page=4 , maybe it depends on the firmware version of the module
Old Feb 21, 2012, 05:51 AM
Frazz is offline
Find More Posts by Frazz
Registered User
Thank you, Yurip. I'm thinkin too that's the problem is channel count, but nothing changes after I modify code increasing channels to 8 (lay-z send default 6ch because the 6 possible controls on the nunchuck) .
Maybe I'm doing something wrong.
I'll do more tests and report here.
sandro
Old Dec 15, 2013, 10:46 AM
geofrancis is offline
Find More Posts by geofrancis
nothing is unfixable
what wires go where to use the flytron firmware with an arduino board? or do you have a photo of the underside of your pcb?
Last edited by geofrancis; Dec 15, 2013 at 10:57 AM.
Old Nov 17, 2014, 01:37 PM
Avioron is offline
Find More Posts by Avioron
Registered User

Hi frazz can u give as the scheme to the layout , and the code ?


I would like to build one .
Thanks .
Old Dec 02, 2014, 03:38 AM
pierrotm777 is offline
Find More Posts by pierrotm777
Registered User
pierrotm777's Avatar
Very nice project


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question Stand-alone Telemetry system? bigdealaerospace UAV - Unmanned Aerial Vehicles 2 Oct 21, 2011 06:57 PM
Discussion Setting up a stand alone pitch controller redboat219 Submarines 2 Sep 19, 2011 12:49 AM
Question Stand alone fail safe unit (failsafe) igorek82 Radios 5 Jul 01, 2011 10:24 AM
Question Stand alone fail safe unit (failsafe) igorek82 FPV Talk 0 Jun 30, 2011 12:23 PM
Discussion What isthe best stand alone gimbal gyro? milo12 Aerial Photography 1 May 30, 2011 03:25 PM