Parkzone 52.5" Icon A5
What I wanted was a foam flying boat that would need minimal modifications to get in the air. I looked at some of the Cessna 182s, the Sea Wind, and some of the Guanli models but all of them seemed like they would need a fair amount of work to get them into the air. The goal was to have a plane that I was not very invested in, so that I could fly off of water with little to no pucker factor.
So far the Icon has been great. I've only got four flights on it at this time, but so far it meets my expectations. I am having the wag/dutch roll issue that everyone else seems to be having but it's not the end of the world, it still flies fine. I hope to spend a lot of time at the lake this summer since I won't have to worry about getting my two favorite wooden planes wet (Toledo and Taylorcraft).
The specs on the Icon:
Static test: 220 watts
Icon A5 PNP
480 960kv outrunner
9" x 8" x 3 prop
(2) SV80 micro servos - ailerons
(1) DSV130M micro digital servo - elevator
(1) HS-82MG servo - rudder
30 amp pro ESC
Ultra 3s1p 2200mah 35c lipo
AR636 AS3X receiver
Last edited by CyberJay; Mar 06, 2016 at 10:55 AM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||ParkZone Icon A5 BNF or PNP||ElIntocable||Waterplanes||5387||Nov 20, 2016 04:04 PM|
|New Product||ParkZone Icon A5||Dave Eichstedt||Parkflyers||290||Nov 03, 2013 10:37 PM|
|Discussion||New Parkzone Icon A5||friz||Electric Plane Talk||66||Apr 09, 2013 05:05 AM|
|New Product||Parkzone Icon A5 Amphibian||SupaRC||FPV Talk||3||Oct 28, 2011 11:07 PM|
|Discussion||ICON A5 by Parkzone||Kinnerhatz||Waterplanes||1||Jul 28, 2011 11:57 PM|