|
|
|
|
Thread OP
|
Question
Temp Probe for Gas Engine CHT
I have installed the temp loop around cylinder head of DA-85 gas engine and connected to Tmp 1 port but have not ran test with MicroPower V3 eLogger.
Is this probe and wire suitable for these higher temps or is another method recommended? |
|
|
Last edited by Capt Dave; Feb 11, 2012 at 06:08 PM.
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Similar Threads | |||||
| Category | Thread | Thread Starter | Forum | Replies | Last Post |
| Y harnessing a temp probe? | gulio | Batteries and Chargers | 10 | Oct 23, 2011 11:33 AM | |
| Dynam Supermate temp probe? | UlteriorModem | Batteries and Chargers | 6 | Sep 19, 2011 10:54 AM | |
| What cut-off temp to use for Triton thermal probe? | Peter Young | Batteries and Chargers | 2 | Jun 15, 2003 05:52 PM | |