OSD pro system failure
I just recieved my OSD pro system with elogger both V4 and both patched
with the latest firmware. When I power the system up on the bench all
work fine I see the on screen display all work as expected. after
about 45-60 seconds pass i loose display with static if I pull the
power from the main batery to the elogger I get the clear black then
when i plug it back in i get static. If I let it sit for a few minutes
it comes back up and repeats the problem. I know it sounds like
something is heating up and shutting down but all componants are
barely warm at the time of problem. I have the Fat shark predator googles
and fat shark 5.8 100mw TX and fat shark ccd killer.
If its more than 4 you need to connect at least one wire from receiver to the osd.
I would try connecting a wire even if you only are using 3 or 4 cells, and see if that fix your problem.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||Complete ET OSD Pro System||Moose2||FPV Equipment (FS/W)||6||May 03, 2011 09:24 PM|
|For Sale||Eagle Tree OSD/AutoPilot Pro Complete System||Alvid98||FPV Equipment (FS/W)||1||Apr 25, 2011 07:53 AM|
|Contest||Win an Eagle Tree OSD Pro System||Grandcaravan||FPV Talk||0||Aug 17, 2010 04:07 PM|
|For Sale||3x Complete OSD PRO System with GPS -cheap||digiflynet||Aircraft - General - Miscellaneous (FS/W)||3||May 11, 2010 10:20 PM|
|Question||Wires for GPS on Eagletree OSD Pro system?||Fishbone4u||FPV Talk||3||Jan 30, 2010 10:26 PM|