Shop our Airplanes Products Drone Products Sales
Thread Tools
Old Feb 07, 2012, 11:09 AM
matphlox is offline
Find More Posts by matphlox
Registered User
Help!

Channel 6 and 2 on Futaba T6J


Hello everybody,

I'm very new to RC world, and I started with a Futaba T6J.
It's all OK, expect channel 6 (usually for flaps, not essential at the moment for a 2 or 3 axes aircraft), supposed to be controlled by the rotary knob.
When I attach a servo on receiver's channel 6, it's like it was controlled by channel 1 (ailerons), its signal is like "replicated" on channel 6, the rotary knob has no effect on anything.
Why? Am I missing something? Like a kind of preprogrammed mixing between channel 1 and 6 in the radio? I don't think so...

Thank you,
Regards,

Mathieu
Sign up now
to remove ads between posts
Old Feb 07, 2012, 01:03 PM
slipstick is offline
Find More Posts by slipstick
Registered User
It sounds like you have FLAPERON mixing (for dual aileron servos) enabled (page 38/39 in the manual). That uses Ch1 and Ch6 for the two servos. Switch that back off and all will be back to normal.

Steve
Old Feb 08, 2012, 02:52 AM
matphlox is offline
Find More Posts by matphlox
Registered User
Thank you Steve, that was exactly the issue. I couldn't expect to get an answer with the manual page too ;-)

Mathieu


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold REDUCED!!! Futaba T6J FHSS 2.4GHz Radio MASHTON Aircraft - General - Radio Equipment (FS/W) 7 Jan 23, 2012 10:13 AM
Sold Futaba R6106HF 2.4GHz FASST 6-Channel Park Flyer Receivers(2) HD Hucker Aircraft - General - Radio Equipment (FS/W) 1 Jan 03, 2012 11:00 AM
Question futaba 6exp 6 channel good for 2-2.5km? custom t FPV Talk 0 Nov 23, 2011 08:56 PM
Sold Futaba 7C 2.4 radio, Three 7 channel receivers, and One 6 channel Receiver SSYeats Aircraft - General - Radio Equipment (FS/W) 5 Oct 06, 2011 02:31 PM
New Product Futaba T6J 2.4Ghz jumboman Radios 0 May 03, 2011 07:31 PM