Adding an accelerometer to a KK+ board - RC Groups
Thread Tools
This thread is privately moderated by HappySundays, who may elect to delete unwanted replies.
Jan 28, 2012, 03:09 PM
OpenAeroVTOL developer
HappySundays's Avatar

Adding an accelerometer to a KK+ board

Following on from my big write-up of how to attach an accelerometer board to a Blackboard, here is the very simple guide on how to do it to a KK+ board

Step 1. Connect your ACC board as shown. The signal names are written on the underside of the KK+ board.
Step 2. Remove the two upper-most pot resistors (Pitch and Roll pots)
Step 3. Adjust Vref to 2.4V

The ACC board orientation is the same as in the following blog entry.

Last edited by HappySundays; Jan 29, 2012 at 05:32 AM. Reason: Wrong resistors noted...
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Rave HK KK V2 Quad board (and other recent KK boards) randall1959 Multirotor Drone Electronics 2584 Aug 11, 2014 03:01 PM
For Sale KK KR1.7 ,ESC Board and KK Frame terriwang Aircraft - Electric - Multirotor (FS/W) 3 Jul 26, 2011 05:22 PM
Discussion interfacing accelerometer to an 8051 jayanthyk192 DIY Electronics 4 May 02, 2011 12:28 PM