Hello guys...

Here is my last build, C-130 Hercules, it is kit cutted from EPP which I bought from http://www.rcfly.cz/elektry/herkules.htm . Wingspann: My setup is:

2 x motor TURNIGY 2830/1050kv with original APC prop 9x6 SF - inside
2 x motor TURNIGY 2826/1350kv with original APC prop 8x6 SF - outside
4 x ESC HOBBYKING SS 20A (card programable)
2 x lipoly ZIPPY 3S 3000mAh 20-30C for motors
3 x servo TURNIGY TGY-90s for ailerons and rudder
1 x servo HITEC HS-225BB for elevator
1 x servo TURNIGY TGY-3317MG for front leg control
1 x TURNIGY MEGABEC 8A
1 x lipoly ZIPPY 2S 1300 mAh 15-20C for receiver and servos
1 x scale TURNIGY R/C LED lightning system

More pictures later when model will completely done with new camouflage. ENJOY

Too cool! That is one impressive bit of engineering and building! I cant wait to see the finished aircraft. NIce job!

Very Nice!

Good job!

Thanks.

I have to make some structural changes and than cooling to produce batteries and some scale details. Then lot of filler, sanding and model will ready for paint.

Today I sanded the hull of front of the fuselafe and I made some construction changes, I have to make the battery cooling today and then only have to model fully sanded smooth. On Monday, I am going to make new camouflage...

:dlooks great:d

Battery cooling is done...

Very very cool! Great details!

subbed

subbed

READY TO MAIDEN FLIGHT...I have to wait for new battery and will be ready for maiden flight, model is completely done...I like this color scheme...I will upload a video and some pictures from maiden...ENJOY

And here is a video and some new pictures from first taxi test...

C-130 Hercules EPP first taxi test (2 min 47 sec)

Nice job, can hardly wait to see it fly.

nice work