|
||
|
Quote:
|
|
|
||
|
|
|
|
You use the Servo Trim tab to set the servo arms at 90 degrees (this will give you symetrical movement up and down), you then adjust the lengths of the Servo arm to swash links to get the swash level.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Last edited by ptern; Feb 13, 2012 at 09:15 PM.
|
|
|
|
|
|
|
|
|
|
I got my bluetooth adapter in the mail today. The good news is IT WORKS!!! I can now connect to my heli without the USB link. I just run John's app and click connect (COM5). The bluetooth links and I get 3 green lights. Everything works fine.
So optional it can be mounted on the heli or moved between helis for wireless connectivity. Full details to come... |
|
|
|
||
|
Quote:
|
|
|
||
|
||
|
Quote:
|
|
|
||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FBL Bluetooth Interface
The Bluetooth unit can be obtained here: http://www.ebay.com/itm/290636551744 The 3GYS data lead here: http://www.rc711.com/shop/alzrc-3gys...le-p-5684.html [Click pictures to enlarge] The lead to the program box and USB link is: GND - Red VCC - Black TXD - Red RXD - White The lead to the bluetooth unit is: VCC GND TXD RXD This means that two wires in the program box lead have to be swapped. Carefully slide off the heat shrink and remove the read and black lead closest to one end. Be careful lifting the little plastic arms to remove the leads. Reinsert the leads the other way around: VCC - Black GND - Red TXD - Red RXD - White Connect the lead to the Bluetooth unit with the visible gold pins facing up. Power up a heli with the FBL unit and plug in the bluetooth lead to the gyro. The red LED will flash. Search for bluetooth devices on the PC/laptop. "linvor" will be detected. Add the device and enter a pin code of "1234". If it then asks to add a coms port to the device, check this and proceed (note the com port allocated). The red light on the bluetooth unit will go solid. Turn on your Tx and wait for the gyro to initialize. Run John's app, select the com port noted above and click connect. You should get 3 greens lights, after a short delay. As mentioned the unit weights 3.6g and with the 3GYS program box lead 6g. Of course you don't have to mount the bluetooth unit on the heli, you can just use it instead of the USB link, as a wireless connection. Just plug it into the gyro you want to change/program. |
|
Last edited by beenflying; Feb 14, 2012 at 05:08 AM.
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Sold | Darthdrk Drone CX Body for coax helis like the Blade CX etc. | Twmaster | Aircraft - Electric - Helis (FS/W) | 0 | Oct 08, 2011 07:31 PM |
Multiplex mc V2 servo programming PC software | Thomas B | Radios | 3 | Jul 23, 2006 09:49 AM |