esc/motor wires etc etc
Hi folks I tried this in the EDF forum...not one response from them,
So I thought i would ask here......its reall about which wires to extend..
I am relatively new to DF stuff and have a question or two.
The motor/DF unit is at the back of the aeroplane, as is the receiver etc (2,4). The plans show the ESC right up front with the battery with long extensions to the 3 x motor cables. and short ones from the ESC/Battery. I imagine this was done to reduce interference with the older 35mHz sets?
Is this the best way to do it?....or can I just extend the two power wires to the front and have everything else at the back, including the ESC?
Any advice would be great......I also plan using a separate BEC, taking power from the main Battery, this will mean yet another wire travelling the length of the aeroplane....i.e 3 x motor cables, ESC/Rx wire, and the BEC /Tx
Cheers for now
Good on ya for replying.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Cool||HobbyKing Buddy-Codes! Plush ESC, Metal Gear Servo, Wires/Bolts/glue, etc!||discotrio||Hot Online Deals||1||Jan 02, 2012 03:08 AM|
|Discussion||ESC Wire Length - Better to extend motor wires?||nioa||Castle Creations||0||Dec 16, 2011 03:40 AM|
|Discussion||Wires from ESC to Motor||Lockey||Pusher Prop Jet Models||7||Oct 15, 2011 08:46 AM|
|Question||What wires on a Fiego motor correspond to ABC on a brushless ESC?||zanek||Racing Boats - Electric||22||Aug 12, 2011 06:38 PM|
|Discussion||Which wires on ESC going to motor are positive/negative and signal wire?||cannondale1974||Power Systems||11||May 15, 2011 09:57 AM|