Thread Tools
Aug 08, 2012, 08:22 PM
Jake From Planet Mascoutah, IL
Jake8131's Avatar
Quote:
Originally Posted by ColSonders
I just got one of these, managed to have a little play in the living room before I was dragged out to dinner by the wife.

I must say I've never had any interest in stuff other than helicopters but this thing made me smile from ear to ear just with a little bit of hovering.

I found it to be VERY twitchy on the cyclic, i'm just using a DX5e at the moment, does anyone know if using the channel 5 switch on that handset puts the MQX into low rate mode? or is there another way of doing it? I know I can use the low rate of my DX5e, but even with that on it seems incredibly twitchy, the thought of taking that outside as a complete newby makes me think "crash"
The channel 5 switch does absolutely nothing. The hi/low rate switch on the right does that.
Sign up now
to remove ads between posts
Aug 09, 2012, 01:08 AM
Jake From Planet Mascoutah, IL
Jake8131's Avatar

Glow In The Dark MQX


Here is a better picture with a McDonalds large coca-cola cup cut at the bottom...definitely glows nice in the dark.

Aug 09, 2012, 01:29 AM
Registered User
not103's Avatar

Parrot ARDrone style indoor protection kit


Is there any kit to protect the propellers for indoor flight?
A kit like the one for parrot would be a great idea!

Aug 09, 2012, 02:48 AM
Suspended Account
Quote:
Originally Posted by ColSonders
For the lighting I've got some fairly bright LED's kicking about that don't require additional resistors for this sort of voltage,
All LEDs require a resistor. To not use one is like putting a piece of wire across the battery terminals. Expect the LED to get very hot and bright for about 0.5seconds.

http://led.linear1.org/category/led-basics/

Edit: Unless they are in series and you do the relevant forward voltage calculation. I prefer them in parallel with a resistor.
Last edited by Brandigan; Aug 09, 2012 at 02:53 AM.
Aug 09, 2012, 02:56 AM
Suspended Account
Quote:
Originally Posted by not103
Is there any kit to protect the propellers for indoor flight?
A kit like the one for parrot would be a great idea!
People have made similar shapes out of lightweight foam or polystyrene ceiling tiles. Can't find the pictures just now. I'm sure someone else will.

You may find the extra weight might make it harder to fly, which might make it more likely you bump into walls, which would mean you'd need protection, which makes it heavier and harder to fly....

Edit: Here it is in the Beetle v929 thread: https://www.rcgroups.com/forums/show...n#post22298127

And here on a Walkera Ladybird:https://www.rcgroups.com/forums/show...postcount=1010
Last edited by Brandigan; Aug 09, 2012 at 08:34 AM.
Aug 09, 2012, 10:20 AM
Registered User
I am having trouble with my MQx. When I give it full throttle it goes crazy. Wild gyrations back and forth and nearly zero control over what happens next. Is that caused by something I have set wrong on my DX6i or is there something wrong with the MQx?
Thanks,
Joe
Aug 09, 2012, 12:07 PM
Jake From Planet Mascoutah, IL
Jake8131's Avatar
Quote:
Originally Posted by MOfroggy
I am having trouble with my MQx. When I give it full throttle it goes crazy. Wild gyrations back and forth and nearly zero control over what happens next. Is that caused by something I have set wrong on my DX6i or is there something wrong with the MQx?
Thanks,
Joe
Have you done anything to it, changed the blades? Try rebinding it.
Aug 09, 2012, 12:50 PM
Registered User
If there is an imbalance between motors with respect to power output, there will be the dancing and jigging described above. When I purchased my third one new, with zero crashes, it would go nearly straight up smoothly, but after a couple crashes, it has a bit more wobble to it. Eventually, I expect the performance difference to be more pronounced and will jig around as your does.
Aug 09, 2012, 12:59 PM
Rocket Programmer
jasmine2501's Avatar
Quote:
Originally Posted by MOfroggy
I am having trouble with my MQx. When I give it full throttle it goes crazy. Wild gyrations back and forth and nearly zero control over what happens next. Is that caused by something I have set wrong on my DX6i or is there something wrong with the MQx?
Thanks,
Joe
No its because with all four motors at full speed, there is nothing left for control.
Aug 09, 2012, 01:03 PM
Vertical approach specialist
potshot's Avatar
It's odd how different our experiences are. Mine is still quite new; I've run maybe 8 or 10 batteries through it. I've crashed it many, many times and am amazed how durable it has been. I often fly it over a concrete patio and I've crashed it there from 8-10 feet high several times, once even upside down. After the inverted crash I had to push the motors back into their mounts so the gears engaged again, but every time it flew nicely afterward.

After a crash I let it sit for a moment to give the electronics a chance to settle down. A friend told me about shutting the Tx off for a few seconds and then back on while the battery is still plugged in. He says that lets everything reset itself - I tried it and it doesn't lose the bind. You can even shut the Tx off in flight and the thing lands itself!

I'm sure I haven't reached the severity or number of crashes that others have, but I'm amazed that there has been no damage to this thing so far.
Aug 09, 2012, 04:44 PM
Jake From Planet Mascoutah, IL
Jake8131's Avatar
Short flight in my living room.

MQX E (1 min 2 sec)
Aug 09, 2012, 08:03 PM
Licensed Lunatic
iamsuperbleeder's Avatar
Quote:
Originally Posted by fred_dot_u
If there is an imbalance between motors with respect to power output, there will be the dancing and jigging described above. When I purchased my third one new, with zero crashes, it would go nearly straight up smoothly, but after a couple crashes, it has a bit more wobble to it. Eventually, I expect the performance difference to be more pronounced and will jig around as your does.
same story with mine. would climb vertical at full throttle relatively stable when it was new, but after 30 flights or so that's not the case. full throttle is pretty much useless, lol. doesn't really bother me too much until it's time to throttle up and recover out of a low loop or something; then things get hairy. it probably wouldn't hurt to change my props though; one's pretty beat up...
Aug 09, 2012, 08:06 PM
Licensed Lunatic
iamsuperbleeder's Avatar
Quote:
Originally Posted by Jake8131
Short flight in my living room.

http://www.youtube.com/watch?v=jQNaZQWDLcU
lol, your cat is like "whatever dude"

my cat isn't so calm when I pull my MQx out and my dog just wants to kill it, lol

the dog has never liked any of my RCs... I use to entertain myself for hours with him when I had my Traxxas mini

mini summit RC hating chihuahua (3 min 54 sec)
Aug 09, 2012, 10:07 PM
Registered User
Quote:
Originally Posted by kosem
Very nice!
Sorry for the dumb question but what kind of paint do you use?
I prefer the ACE Hardware Fluorescent Orange over the Rust-Oleum Fluorescent.

I started experimenting with spray painting propellers many months ago, I probably painted 30 blades before they came out with their orange blades. And this is my second attempt at painting the body.
Last edited by TomQ; Aug 09, 2012 at 10:44 PM.
Aug 09, 2012, 10:25 PM
Registered User
Quote:
Originally Posted by kodak_jack
A McDonalds clear dome cup top will give good protection, minimal weight and minimal drag in motion. Don't fly naked!
Quote:
Originally Posted by raw89
I agree w/ Kokak Jack except I prefer a Motts applesauce tub.:
Quote:
Originally Posted by Thetis
If you walk through Walmart or any any other similar store the plastic covers of cheap products are the best candidates. Flying naked is a risk taking for the expensive electronic board. Better be safe than sorry
Quote:
Originally Posted by BlueHavoc
Thats what I use, very light but protective....
I have flown more than 100 topless flights and I have had more than 400 unintended stoppages during those flights, many of them at dawn with very heavy dew. I replaced 6 or 7 control boards during my first 750 flights, almost none of those flown topless and yet I have not replaced a control board since going topless. I stand by my recommendation of flying topless. I only speak from experience.

What makes you advise otherwise?


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold BNF PZ J3 Cub, BNF PZ P-51D Mustang, Blade mSR RTF & DX6i nyaaah!! Aircraft - Electric - Micro & Indoor Airplanes (FS/W) 11 Oct 06, 2011 11:21 AM
For Sale New Blade 400 RTF Will sell as BNF papower Aircraft - Electric - Helis (FS/W) 8 Aug 04, 2011 12:28 PM
Sold ON HOLD....FS/WTT Like New (RTF) Heli-Max AXE CPv3 For Like New (BNF) Blade mCP X ABADGTP Aircraft - Electric - Helis (FS/W) 0 Jul 26, 2011 07:22 PM
Sold Blade MCX2 Like New RTF or BNF tamiyafan1975 Aircraft - Electric - Helis (FS/W) 1 Jul 14, 2011 03:39 PM
Sold Blade mCPX RTF or BNF (factory sealed new in box) PatternFlyer Aircraft - Electric - Helis (FS/W) 5 Mar 28, 2011 03:25 PM