Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by Graham 65, who may elect to delete unwanted replies.
Old Dec 11, 2011, 04:52 PM
Graham 65 is offline
Find More Posts by Graham 65
Registered User
Graham 65's Avatar
Build Log

Bubble Dancer Electric


Top sheeted the centre section, with 3/32 sheet, its more than 4" wide so takes 2 sheets and they need to be 48" sheets, I know now!
The servo holders or at least the trays are in place as is the wiring along with a 4 pin socket for connecting when putting the wing on.
The end ribs have been bevelled to 5 degrees and the joiners are being glued in. This is out of proper order and would be easier to do in the correct order, ie when the wing is just a spar and ribs.
Sign up now
to remove ads between posts

Thread Tools