Will this slightly different mixer set up for an Octo work?
I'm about to put together my WK-M and was wondering, would there be any reasons not to run my mixer set up like in this diagram?
I want to run 2 overlayed X shapes each on different batteries for better redundancy.
If I did that with the normal mixer setup (where each prop rotates in a different direction) then if one battery went down then all of the other props would be spinning the same direction.
This setup would alleviate that. I call it Octo x on +
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Will this work for an octocopter frame design?||webgeek||Multirotor Drone Talk||6||May 13, 2011 03:44 PM|
|Help!||Has anyone tried this? Will it work good for my set-up?||hot glue||Power Systems||1||Jun 11, 2008 06:05 PM|
|Discussion||Slightly different idea for twin boom pusher, will it work?||Hellbore||Aerial Photography||21||Sep 14, 2007 12:20 PM|
|Power Set Up for an SRBatteries AcroPro- Will a Mega 16/15/7 or 22/20/4 Work???||ClipperBill||Power Systems||0||Oct 31, 2004 07:55 PM|