Shop our Airplanes Products Drone Products Sales
Thread Tools
Old Nov 16, 2012, 11:53 AM
voloelettrico is offline
Find More Posts by voloelettrico
Registered User
voloelettrico's Avatar
Hello alek3d
I saw in the Frame ecilop network, are very beautiful and professional video to make important I think it is a good choice.
For now I have no problem to make professional videos, only at amateur level
however memorize in case of need.
thanks
Sign up now
to remove ads between posts
Old Nov 16, 2012, 02:05 PM
shuricus is offline
Find More Posts by shuricus
Moscow
shuricus's Avatar
Hi!
Can you please help me where to connect signals from Bluetooth RF Transceiver Module RS232 to FF white board to use with TC firmware?

- TXD:
- RXD:
- V

Last edited by shuricus; Nov 16, 2012 at 02:54 PM.
Old Nov 20, 2012, 02:10 PM
voloelettrico is offline
Find More Posts by voloelettrico
Registered User
voloelettrico's Avatar

FF Flight


Hello Rcjose
I did a flight with FPV quadricopter FF flight.
I have tried to do better with FF Flight
Here's the video
FPV_Con_Quadricottero_Nel Parco (3 min 32 sec)
Old Nov 20, 2012, 03:23 PM
rcjose is offline
Find More Posts by rcjose
Registered User
Quote:
Originally Posted by voloelettrico View Post
Hello Rcjose
I did a flight with FPV quadricopter FF flight.
I have tried to do better with FF Flight
Here's the video
http://www.youtube.com/watch?v=Wl6miCvfQU4&feature=plcp
Good work. The quad looks stable at higher altitude. Flying low to the ground always causing prop wash which makes the quad drift around. What camera are you using for FPV and recording video?
Old Nov 20, 2012, 03:45 PM
voloelettrico is offline
Find More Posts by voloelettrico
Registered User
voloelettrico's Avatar
Quote:
Originally Posted by rcjose View Post
Good work. The quad looks stable at higher altitude. Flying low to the ground always causing prop wash which makes the quad drift around. What camera are you using for FPV and recording video?
Hello
The Cam is numbered WING2 HobbyKing
for me it is a good alternative to the GoPro etc. ... etc. ...
Old Nov 20, 2012, 04:44 PM
rcjose is offline
Find More Posts by rcjose
Registered User
Quote:
Originally Posted by voloelettrico View Post
Hello
The Cam is numbered WING2 HobbyKing
for me it is a good alternative to the GoPro etc. ... etc. ...
So I can assume that you are just recording video and flying it line of sight (looking at it). If so, that's not FPV. That's just recording your flight. FPV is where you are flying/controlling it by viewing what the camera views live.
Old Nov 20, 2012, 05:07 PM
voloelettrico is offline
Find More Posts by voloelettrico
Registered User
voloelettrico's Avatar
Quote:
Originally Posted by rcjose View Post
So I can assume that you are just recording video and flying it line of sight (looking at it). If so, that's not FPV. That's just recording your flight. FPV is where you are flying/controlling it by viewing what the camera views live.
Hello
I do not know if I understand you correctly? I try to explain.
I use 2 Cam (1 to drive FPV) (2 WING2 for registration FPV)
Old Nov 20, 2012, 05:41 PM
rcjose is offline
Find More Posts by rcjose
Registered User
Quote:
Originally Posted by voloelettrico View Post
Hello
I do not know if I understand you correctly? I try to explain.
I use 2 Cam (1 to drive FPV) (2 WING2 for registration FPV)
Ok, that makes sense. Yes, you are truly flying FPV then.
Old Nov 21, 2012, 03:22 PM
MrDusanmandic is offline
Find More Posts by MrDusanmandic
Closed Account
I just flashed my Free Flight FC with the Base Flight firmware but have a few questions / issues.

First, does anybody have a diagram on how the ESC's are connected and in which order, along with the receiver connections?

Second, I can arm the FC by pushing the throttle stick to the right, but I can't disarm when pushing to left.

Third, how do I make changes to the multiwii code that's on the FF board? I don't want the motors to spin upon arming it.

Any help is greatly appreciated.
Old Nov 21, 2012, 07:12 PM
helizrnew2me is offline
Find More Posts by helizrnew2me
Registered User
helizrnew2me's Avatar
Quote:
Originally Posted by MrDusanmandic View Post
I just flashed my Free Flight FC with the Base Flight firmware but have a few questions / issues.

First, does anybody have a diagram on how the ESC's are connected and in which order, along with the receiver connections?

Second, I can arm the FC by pushing the throttle stick to the right, but I can't disarm when pushing to left.

Third, how do I make changes to the multiwii code that's on the FF board? I don't want the motors to spin upon arming it.

Any help is greatly appreciated.
set the travel on the rudder to 125 in both directions using the travel adjustment within the tx .that should allow you to arm/disarm

for motor stop you need to go into arduino sketch ,load up the sketch ,then define motor stop .

this video should help you

MultiWii Arduino Sketch mod and Upload (2 min 22 sec)


i had to learn this myself and once you figure it out its easy .i can make changes in seconds ,takes longer to upload the changes then it does to make them .be sure to save your sketch once done compiling it .
what version software are you using?
Old Nov 21, 2012, 09:50 PM
thwaitm is offline
Find More Posts by thwaitm
Team WarpSquad
Quote:
Originally Posted by MrDusanmandic View Post
I just flashed my Free Flight FC with the Base Flight firmware but have a few questions / issues.

First, does anybody have a diagram on how the ESC's are connected and in which order, along with the receiver connections?
Try the naze32 manual here: manual

Quote:
Originally Posted by MrDusanmandic View Post
Second, I can arm the FC by pushing the throttle stick to the right, but I can't disarm when pushing to left.
I'm using my gear switch instead of just the sticks because of this.

Quote:
Originally Posted by MrDusanmandic View Post
Third, how do I make changes to the multiwii code that's on the FF board? I don't want the motors to spin upon arming it.
Try using putty or Hercules to connect to the board directly and change the settings that way or use the interface provided by nicodh https://www.rcgroups.com/forums/show....php?t=1667516

Quote:
Originally Posted by MrDusanmandic View Post

Any help is greatly appreciated.
Old Nov 22, 2012, 11:01 AM
MrDusanmandic is offline
Find More Posts by MrDusanmandic
Closed Account
Quote:
Originally Posted by thwaitm View Post
Try the naze32 manual here: manual



I'm using my gear switch instead of just the sticks because of this.



Try using putty or Hercules to connect to the board directly and change the settings that way or use the interface provided by nicodh https://www.rcgroups.com/forums/show....php?t=1667516
One of the confusing parts is, where is the baseflight "sketch" for me to modify and then upload to the FreeFlight board?

Also, in the Arduino IDE app, which board do I pick before I hit upload to update the sketch on the board?
Old Nov 22, 2012, 05:12 PM
eDoug is offline
Find More Posts by eDoug
Registered User
eDoug's Avatar
You don't need to alter sketches with baseflight32, settings are changed through CLI. Read the manual in the link thwaitm provided..

Might be worthwhile reading up here and here.
Old Nov 22, 2012, 11:14 PM
MrDusanmandic is offline
Find More Posts by MrDusanmandic
Closed Account
Last question, why do all of the manuals for these boards say it can't be used on DJI frames?
Old Nov 22, 2012, 11:24 PM
helizrnew2me is offline
Find More Posts by helizrnew2me
Registered User
helizrnew2me's Avatar
Quote:
Originally Posted by MrDusanmandic View Post
Last question, why do all of the manuals for these boards say it can't be used on DJI frames?
vibration

if it wasnt for the low pass filters in multiwii my dji450 wouldnt be flying .tried it with no filter and it was bad . jitter-ed like mad.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold Complete MultiWii Quadcopter Flight Controller madushan2008 Aircraft - Electric - Multirotor (FS/W) 3 Aug 11, 2011 09:25 AM
Sold FY90Q Flight Controller for Quadcopter - $70 shipped jpsabo Aircraft - Electric - Multirotor (FS/W) 1 Jul 29, 2011 11:21 AM
For Sale Complete MultiWii Quadcopter Flight Controller Kit madushan2008 Aircraft - Electric - Multirotor (FS/W) 7 Jul 26, 2011 09:58 AM
Sold Multi Wii flight controller with auto level ver 1.7 tc3wins Aircraft - Electric - Multirotor (FS/W) 1 May 08, 2011 02:02 AM
Video Trex SE...3d flight with auto Nick Maxwell Electric Heli Talk 10 Dec 18, 2006 10:23 PM