Thread Tools
This thread is privately moderated by Jim.Thompson, who may elect to delete unwanted replies.
Nov 29, 2011, 09:16 PM
Entropy is happening!
Jim.Thompson's Avatar
Thread OP
Discussion

Wing skin layup started!


I now have the moulds all prepared, waxed PVA and primed. The first (bottom) skins layup is under vacuum. One layer of 100gsm plain weave glass and balsa core in front of the spar and 2 mm foam core behind the spar. I will install the spar cap tow tomorrow and the internal layer of 100 gsm glass and vac bag again.

Jim.
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion DLG Wing Repair Layup? jtprouty Composites Fabrication 2 Dec 01, 2011 10:22 PM
Discussion Fiberglass orientation for wing skin marco_ul Composites Fabrication 18 Nov 09, 2011 06:30 PM
Question Replacement for 1/16 balsa wing skin r140racer Composites Fabrication 25 Oct 20, 2011 04:50 PM
Question Voids in carbon skin layup. samotage Composites Fabrication 40 Aug 05, 2006 10:57 PM
Sanding Foam Core / Skin Layup Air Head Composites Fabrication 7 Mar 07, 2005 07:27 PM