1/3 scale Albatros Dv or Dva spinner
I have a few handmade Albatros Dv / Dva spinners for sale. They are spun aluminum with aluminum backplate machined to fit. They are also capable of being used for a 1/3 Siemens Schuckert if you wish. You can see what it looks like on a Siemens in this build thread:
The outside diameter of the spinner at the backplate is 7.875 inches. The center hole in the backplate is reamed to .376 (3/8 +.001 inch) so if you need another size let me know.
If you were holding off on doing a 1/3 scale Albi for lack of a nice spinner, your wait is over. You won't find a nicer spinner for the price anywhere. You probably won't find a nicer one for a much higher price either...
I also do the same profile in 1/4 scale if you need one of those.
I will let these go for $125shipped to you insured USPS Priority in the USA. Check the other guys price on a 1/3 scale spinner and see how I compare.
Thanks for your consideration.
Last edited by mcjustis; Dec 13, 2011 at 05:52 AM. Reason: Price Drop
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Build Log||Peter Rake 1/6 Scale Albatros DVa||hammerd||Scale Kit/Scratch Built||914||Dec 29, 2014 05:04 PM|
|For Sale||1/4 scale Albatros Dva fuselage formers||mcjustis||Aircraft - Fuel - Airplanes (FS/W)||0||Dec 27, 2008 09:52 PM|
|Discussion||Has anyone built or flown the 1/4 scale Proctor Albatros DVa.||Craymar||Giant Scale Airplanes||0||May 14, 2008 10:24 PM|