multiwii nunchuck problem with video and gui screen shot
ok got a bit of a problem here, when ever i activate the nunchuck via my gear switch, the quad tilts backwards and becomes very over exagerated to control.
when off nice control returns, have included a short video of problem and a screen shot of my current gui settings.
one other thing the quad needs alot of left yaw trim to track straight, how do i correct that in the gui pid settings please?
many thanks in advance RCT
>>ok got a bit of a problem here, when ever i activate the nunchuck via my gear switch, the quad tilts backwards and becomes very over exagerated to control.<<
1) Your P value for level is very low. Try to increase the level P value until you have some stability.
2) The quad tilts backwards mean that when you calibrate the accelerometers you were not on a flat surface or your machine is not level. Try to put the machine on a level surface before you calibrate. You can use your transmitter to calibrate by using full throttle stick left yaw full back elevator and full right aileron. Make sure your board is NOT armed first.
>>one other thing the quad needs alot of left yaw trim to track straight, how do i correct that in the gui pid settings please?<<
You correct that by shimming your motors to compensate. If the machine yaw left you need to shim the right side of the motor while looking from outside towards the center.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||multiwii gui prob with video||rcta15||Multirotor Drone Talk||13||Nov 22, 2011 08:17 AM|
|Discussion||A sports Video shot with rc Aerial video & go pro||superek4||Multirotor Drone Talk||4||Nov 01, 2011 07:50 PM|
|Discussion||Multiwii nunchuck woes||AlexnderH||Multirotor Drone Talk||0||Sep 04, 2011 04:34 AM|
|Discussion||Bluetooth GUI MultiWii with WIDCOM drivers||Katch||Multirotor Drone Talk||0||Aug 30, 2011 05:59 PM|
|Discussion||MultiWii GUI freeze troubleshooting||power||Multirotor Drone Talk||16||May 08, 2011 03:14 PM|