Thread Tools
This thread is privately moderated by Jim.Thompson, who may elect to delete unwanted replies.
Nov 25, 2011, 11:51 PM
Entropy is happening!
Jim.Thompson's Avatar
Thread OP
Discussion

Joiner Alignment.


I am now setting up the two lower wing mould halves so that the joiner will be alligned correctly. The parting plane was not on the chord line due to a mistake of mine, so I put the wing plugs in the moulds and set everything up parrallel and level. Then I set the joiner in place level and filled the space in the moulds to fit the joiner. The alighnment pin/rod can be seen in the picture as well.
There was more slight voids to fill in the root ends. When all this cures I will layup some wing skins. Probably some time next week.

Jim.
Last edited by Jim.Thompson; Nov 25, 2011 at 11:56 PM. Reason: Add pics
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question Alignment and fitting of dog bone roach101761 Scale Boats 7 Nov 18, 2011 08:32 AM
Discussion Tail alignment on my foamy raRaRa Electric Plane Talk 3 Oct 15, 2011 03:49 PM
Discussion Twin prop alignment issue remondo Scale Boats 12 Oct 14, 2011 10:51 AM
Discussion Tail case wrong alignment beaver_yeah Fuel Heli Talk 2 Apr 16, 2011 07:03 AM