Thread Tools
This thread is privately moderated by shigetyann, who may elect to delete unwanted replies.
Nov 22, 2011, 09:45 AM
Registered User
shigetyann's Avatar
Thread OP
Discussion

Making nose gear hatch in A488 ICON-A5


Hi, Iíve finished making the nose gear hatch.
I constructed it on a hull that was made by vacuum foaming.
The hull is made of thin plastic plate, itís reinforced by FRP.
Even though, it still has flexibility, the each center of hinges needs certain continuity.
I made the centers using long carbon rods. This way seems to be correct. Even if the hull will be vended, the hinge shall work.
Last edited by shigetyann; Nov 22, 2011 at 09:56 AM.
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Build Log ICON A5 DZ-A488 1800mm Build Review Skyguide Waterplanes 12 Nov 02, 2011 07:16 AM
Sold A488 ICON A5 70" wingspan, EPO, retracts,flaps $75 LPU baddb1 Aircraft - Electric - Airplanes (FS/W) 1 Mar 27, 2011 08:26 PM