Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by Graham 65, who may elect to delete unwanted replies.
Old Nov 09, 2011, 04:50 PM
Graham 65 is offline
Find More Posts by Graham 65
Registered User
Graham 65's Avatar
Build Log

Bubble Dancer Electric


Working on mid sections. The first one is pictured below with progress so far. Have realised that I used 3/32 sheeting on the tip panels which should have been 1/16 so have some careful sanding to correct the issue.
Sign up now
to remove ads between posts
Old Nov 10, 2011, 03:27 AM
chippypilot is online now
Find More Posts by chippypilot
Registered User
Do you still have a day job. I can't believe how fast this is progressing!

Maybe the additional thickness on the tips will allow you to balance the wing by removing weight, rather than adding it.
Old Nov 10, 2011, 04:54 PM
Graham 65 is offline
Find More Posts by Graham 65
Registered User
Graham 65's Avatar
Trying to keep the momentum up, started in early Oct once I had insulated the garage, thinking that it would be finished by Christmas, not so sure now!

The fuselage still needs to be sorted, Hyperflight have run out of booms, which would have been handy to have before making the pod. I have not decided if I should make a mould for the pod or do a one off lost foam job.

Just trying to get something done every day and keep ahead with ordering bits, but not worrying about the motor, servos etc. Time for that later.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Bubble Dancer v Houston Hawk v Yardbird 2 Kookaburra Thermal 20 Nov 04, 2011 02:46 AM