|
|
|||
|
Thread OP
|
New Product
HobbyKing - Mini Racers Edge 540 V3 & Sbach
These are pretty nice
|
||
|
|
|||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
I have been waiting for these.They look fanstastic!
|
|
|
|
|
|
|
|
|
Just ordered the edge!Thought I'd better get my hands on at least one before they are out of stock.I will most likely get all three eventually.
|
|
|
|
|
|
|
|
I was flying the Edge loads yesterday.....mad as a box of frogs....brilliant fun, 1800mAh 4s really is the only pack for them though, C of G is perfect with that size pack, oh and watch those rates on the maiden!
|
|
|
|
|
|
|
|
|
Can't wait!I'll run 1800 4s 40C.
|
|
|
|
|
|
|
|
|
The set up you see on the vid is 1800mAh 4s up front, C of G is bang on, no need for mods, as I said, rates are really important, that roll rate you see on the V3 is at only 50% aileron movement! Elevator needs to be around 50% also for the maiden,maybe set up a little bit more on dual rates for landing, it is essential that it is trimmed right, get it up high and trim for level flight at around half throttle.....then enjoy!
|
|
|
|
|
|
|
|
|
Thanks for the advice Scott.I'll probably throw in some expo as well to soften the controls around center.
|
|
|
|
|
|
|
|
|
Oh for sure!
|
|
|
|
|
|
|
|
|
Well silly me.I got excited watching the video again,and even though I have the Edge on order,I went ahead and placed another order for the Sbach.Maybe they will arrive at the same time?LOL!
|
|
|
|
|
|
|
|
|
Well the Sbach arrived today.Looks fantastic! Should be a very easy assembly.If it takes me more than an hour I'd be surprised.I'm not in a hurry though.I run Deans connectors,but for these I will keep the xt60 connectors on the esc and batts.But I have to wait till my next one,the Edge gets here as I ordered charging leads for these connectors.Maybe this week if I am lucky.I know it has shipped>
|
|
|
Last edited by bouncebk2003; Jun 24, 2012 at 12:45 AM.
|
|
|
|
|
|
I put the Sbach together.Tell you what,make a pot of coffee,and by the time it's done brewing,you will have it assembled.Super simple.Waiting on my charge leads so I can get those 1800 4s batteries charged.Hopefully this week.I have to say,this is one impressive looking plane!
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Similar Threads | |||||
| Category | Thread | Thread Starter | Forum | Replies | Last Post |
| Sold | Raleigh NC Area - E-Flite Mini Edge 540, Grasshopper L4, Ultimate FX 3D, Hyperion | rstoomanyhobbies | Aircraft - Electric - Airplanes (FS/W) | 39 | Oct 03, 2012 12:43 PM |
| For Sale | Eflite Mini Edge 540 Parts | rstoomanyhobbies | Aircraft - General - Miscellaneous (FS/W) | 6 | May 30, 2012 02:39 PM |
| New Product | HobbyKing Mini Racers Edge 540 V3 & Sbach... | micromantis | Foamies (Kits) | 6 | Oct 31, 2011 02:25 PM |
| Wanted | Eflite Mini Edge 540 Parts | jesses151 | Aircraft - Electric - Airplanes (FS/W) | 6 | Oct 04, 2011 07:38 AM |
| Discussion | Fliton Mini Edge 540 or E-flite Mini Edge 540? That is the question. | CGReload | 3D Flying | 4 | Feb 13, 2008 03:17 PM |