Leading edges - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
This thread is privately moderated by kdwzagi, who may elect to delete unwanted replies.
Oct 27, 2011, 03:43 PM
(madkev :) )
kdwzagi's Avatar
Build Log

Leading edges

The top skin leading edge was sanded back to the false leading edge. the first two 6mm leading edges were then glued on. once dry the lower wing skin leading edge was sanded back to the leading edge strips. last of all the front leading edge was glued on. this overlaps the lower skin. sanding these leading edges is next. getting the fuselage front section to mate nicely with the leading edges will be quite a challenge :-(
Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Thinning mylar leading edges? woode Multi Task F3X 18 Oct 03, 2011 02:43 AM
Discussion Smooth leading edges thermal guy Hand Launch 25 Aug 18, 2011 07:41 AM
Discussion Performance - Rounded or square leading edges on flat plate airfoils batbear Modeling Science 9 Mar 21, 2011 04:29 PM
How to do leading edges on vac bagged wings? chlee Electric Sailplanes 7 Mar 04, 2002 09:37 AM