Thread Tools
This thread is privately moderated by indycobra, who may elect to delete unwanted replies.
Oct 25, 2011, 09:26 PM
Trader Rating: 37
Registered User
Thread OP
Sold

Blade MCPX PARTS Control Board - Servos - Motors ...


I had some bad luck with my MCPX so ive decided to sell the remaining parts and buy a new one. While trying to repair a broken tail boom I screwed up the frame and dripped super glue on the rear servo. Left in great working shape are the parts below:

Flybarless 3-n-1 Control Unit $45 Shipped CONUS

MCPX servos (2) $15 Shipped CONUS

Main and tail motor (rear bracket has been cut) $10 Shipped CONUS

Rotating assembly $30 Shipped CONUS (all parts are over $60 at HH new)

Charger and adapter $15 Shipped CONUS

EVERYTHING $100 SHIPPED CONUS
Sign up now
to remove ads between posts
Oct 25, 2011, 10:18 PM
Trader Rating: 16
Registered User
Stugoose's Avatar
are the servos mint, and are they permanently set in that low position if they arent i might bite
Oct 26, 2011, 06:36 AM
Trader Rating: 37
Registered User
Thread OP
since I was flying this thing and the servos are not in the package I wouldnt call them mint. They did work fine when I took it apart.
Oct 26, 2011, 07:34 AM
Trader Rating: 16
Registered User
Stugoose's Avatar
Can u bind them up with the board and take a short vid clip, i want to see if they are permanently set in a lower position, if not ill take them
Oct 26, 2011, 07:55 AM
Trader Rating: 277
I am ready for HHAEFI!!
powerlines's Avatar
HEHEH!! you got no TAIL boom... LOL.. I ben thru 5 of them!!!
Oct 26, 2011, 08:13 AM
Trader Rating: 16
Registered User
Stugoose's Avatar
Do u want to hear my broken part count through various helis


broken helis 4
extra boards 2
booms (well i have about 15 extra tail motors)
Chasis pieces (i have about 10 that i have deemed non repairable)
Im not even gonna get into the rest


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! Mcpx servos stop working or 3n1 board problem Alextherc Micro Helis 33 Oct 25, 2011 09:09 PM
Discussion Blade MCPX -- sometimes yaws left out of control. lawlist Beginner Training Area (Heli-Electric) 0 Oct 24, 2011 05:05 PM
Discussion FRANKEN HELI? BLADE MCPX BOARD WALKERA DIGITAL SERVOS- Will it work? aaronstomfoolery Micro Helis 17 Oct 20, 2011 05:18 PM
Wanted 5 in 1 Control Unit (electronics board) for Blade MSR stevo75 Aircraft - Electric - Helis (FS/W) 1 Sep 11, 2011 08:29 PM
Sold Blade mCPx parts: Servos, swashplates, main motor, etc. yeahyoung Aircraft - Electric - Helis (FS/W) 3 Aug 01, 2011 05:58 PM