SKY706 Simulator port
Is it possible to get a ppm signal (like the FUTUBA) from the SKY706 simulator port, in order to use it with simulators such as pheonix?
I realise the simulator port provides a USB output, but there appears to be more pins on the port than are required for USB.
I thought maybe the additional pins would provide a ppm output?
Personally having setup thousands of these when we bench test before shipping to our customers, unless your Tx is setup for standard 4 channel Airplane type operation, I recommed using a separate simulator controller. Because CCPM control is done in the Tx programming it becomes a problem to use them with many of the flight simulator programs.
However I will check with the factory to see if any of the pinout combinations will give you PPM output
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Cable For Dynam Hawk Sky Simulator Port||andrew99||Power Systems||1||Aug 24, 2011 02:07 PM|
|Discussion||DX6 Trainer/Simulator port||itplachy||DIY Electronics||3||Aug 11, 2011 09:01 PM|
|Wanted:Simulator Cable w/usb Port for futaba to pc||Bookstar75||Aircraft - General - Radio Equipment (FS/W)||6||Feb 26, 2005 04:48 PM|
|need old serial port TX interface cable for Realflight simulator||1g1yy||Simulators||1||Mar 27, 2004 07:38 PM|
|Need old style serial port cable for Realflight simulator||1g1yy||Aircraft - Electric - Airplanes (FS/W)||2||Mar 27, 2004 05:44 PM|