Art Tech Miniwolf SE Bottom Rotor Not Spinning, Help Appreciated.
I have Art-Tech Miniwolf SE, purchased from XHeli few weeks ago... Unfortunately I had a bad spill and ran the helicopter to a wall.
ISSUE: the bottom blade rotor assembly is somehow not attached to the outside center shaft (when center outer shaft is spinning, the bottom rotor does not spin together as if it is not tied together anymore). Because of this, bottom rotor spins somewhat, but not enough to lift the helicopter. Top blade-rotor spins just fine.
I am not sure how the bottom rotor assembly was attached to the outer-center shaft when it was new, does anyone know?? I thought about gluing little piece that is above bottom swash-plate to the outer-center shaft, but wasn't sure of its consequences.
I am wondering if I need a spare part to fix my issue, and if so, can you tell me which spare part(s) I would need? Thanks.
Any help would be greatly appreciated. Thanks in advance!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Top Rotor Not Spinning Properly||Dusty88||Coaxial Helicopters||9||Aug 21, 2013 09:10 PM|
|Discussion||Art tech Miniwolf||JET747||Coaxial Helicopters||39||Aug 01, 2012 03:31 PM|
|Discussion||Brownstone Silver Bullet RC Heli bottom blades not spinning ?||cc114144||Beginner Training Area (Heli-Electric)||1||Sep 28, 2011 07:01 AM|
|Discussion||HELP! bottom rotor of blackstorm heli not spinning anymore||bowlerman13||BladeRunner Heli||0||Jan 06, 2010 08:10 PM|