Replacement Servo for my W852 (Walkerized HQ852) 40cm coax heli. - RC Groups
Thread Tools
This thread is privately moderated by nese, who may elect to delete unwanted replies.
Oct 08, 2011, 04:44 AM
Registered User
nese's Avatar

Replacement Servo for my W852 (Walkerized HQ852) 40cm coax heli.

Just noting here that I used the same servo that's used in the Esky lama v4 fine to replace the busted aileron servo (starboard side), EXCEPT:
- The servo direction was opposite from the stock so reversing the directiom on tje tx was needed.
- The mounting holes on the esky servo needed to be widened by drilling to 2.5-3.0mm so that it would fit the mount just right.

After changing the servo one of the motors failed... Not related. It was about time anyway. Another time...

edit: I actually replaced the front motor that day in 20 mins. Back to flying
Last edited by nese; Oct 09, 2011 at 01:18 PM.
Sign up now
to remove ads between posts
Oct 13, 2011, 11:46 PM
Registered User
nese's Avatar
fixed main shaft

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Looking for replacement blades for HCW 8501 (36 inch 3ch heli) caall99 Coaxial Helicopters 1 Oct 01, 2011 09:53 PM
Question Anything better than Brookstone coax heli? nuggetz Coaxial Helicopters 7 Sep 08, 2011 04:11 AM
Discussion Small metal coax heli for $19.99, today only. Link inside... Heli_Noob Coaxial Helicopters 6 Aug 20, 2011 10:22 AM
Found big coax heli for dl rx ROCKY2 FPV Equipment (FS/W) 0 May 23, 2011 01:04 PM
Help! coax heli vs blade mSR W/ parts support for first heli lwilton651 Beginner Training Area (Heli-Electric) 22 Feb 15, 2011 03:27 AM