DJI Wookong-M Owners Thread *Pics*Videos*Settings*
OK I think we need a thread dedicated to Wookong-M settings,Pics, Vids etc.. The other thread, the info is all over the place. This thread will have dedicated sections for vids,pics,settings,etc.... Hopefully the dealers and manufacturer will also help with tech support here. This will make it much easier for guys to know what works and what doesnt and see proven rigs and the settings used.
Last edited by Z06 Tony; Oct 05, 2011 at 10:12 AM.
Last edited by Z06 Tony; Oct 10, 2011 at 12:49 PM.
VIDEO Of SETUP #1
VIDEO OF SETUP #3
RAW ONBOARD VIDEO:
Better Quality Vid#2-> http://sprealinvest.at/secondWKMirrsee.mov
VIDEO OF SETUP #5:
Last edited by Z06 Tony; Oct 26, 2011 at 01:51 PM.
Setup & Settings:
This setup was used in the vid "Nex5NonWKMHex.wmv"
28" motor to motor
ESC-DYS 30 amp
Graupner 11 x 5 props
Dual 4S 5000mah in parallel
Photohigher AV130 old style with Hyperion servos
JR 11X tx with R921 rx
Rusty's Rev8 frame
Droidworx landing gear
Basic gains roll and pitch 300% Yaw at max, 300%, altitiude at max 250%
ATTI gains, 65 % pitch and roll
All other settings currently at default.
Setup shown in 3rd vid:
2nd Pic in the pics section:
Frame-Droidworx Skyjib8 Octocopter
ESC-Hobbywing Fentium 80A
Props-APC 14 x 4.7
Weight without cam is over 5.5 Kilos
Basic Gains: 175,125,175,75
Frame-RC Carbon 900mm Hexa,
ESC-Plush Turnigy 40a
Props-Carbon Props 12x3.8 Weight-11 grams
TX-Graupner MX-22 with RASST Robbe Model
RX-Futuba R6208 SB Receiver, using S-bus
Cam Mount-AV 130 new Sav÷x servos
Camera-Canon 500D 10-22mm lens about 900 grams
Batt-Nano Tech 6000 mah 4s
Basic Gains: 170
Props-Graupner Electro 11x5 props
ESC-Turnigy Plush 30 ESC's
Frame-Modified RC Carbon Frame and Gear
RX-Spektrum 9010X Receiver
Batts-Dual 4S 5000 Packs
Cam Gimbal-RC Carbon Gimbal
Size-480mm motor to motor CHEAPO wood frame
Motors-1150 kv 3S
GoPro hard mounted(No cam mount)
Basic 130, 130, 220, 110
Atti 140, 140
Frame-Coptersky 500mm folding quad frame
Cam Mount-CopterSky GoPro 2 axis camera mount
Motors-RC Timer 2830/14 motors
ESC-Turnigy Plush 30A escs
Batts-2x3S 2460mAh (I may go to a single 4S 4000mAh later)
2S 1000mAh for the video tX
FPV Setup-200mw 5.8ghz video transmitter
Last edited by Z06 Tony; Oct 04, 2011 at 11:48 AM.
Advance parameter tuning-
Better left alone, it is mainly for forward flight with head wind. Increase for strong head wind. Decrease for strong tail wind.
“V Damping” value
Ascending and descending braking, as to how fast you want the multi to stop. Increase value to have fast braking.
“Disturb Gain” value
Increase to have higher position hold; decrease to have less. Fine tuning between ATTi and GPS modes in position hold.
All advance parameters are only good in GPS mode.
Last edited by Z06 Tony; Oct 29, 2011 at 03:08 PM.
battery voltage monitor
I have now started to run with the new power module, and it works great, no heat buildup coming from an ESC. Also it makes me feel safe about the battery voltage, I have in the past had the quad fall out of the sky because I was not paying attention to how long it was up, and the battery had dropped below a safe value. Now with the settings I've been using, which after looking over the battery graphs I set the values, and it comes down slowly at the very end and I still can control it where I would like it to land. The throttle settings are above neutral point but still can raise and lower it if needed and landed where I would like. Here's an example of my settings and I made to a little adjusting the first setting but so far works great.
New build in Progress Y-6
Here is my Y-6 in progress.
Graupner Electro 11x5 props
Turnigy Plush 30 ESC's
Modified RC Carbon Frame and Gear
Spektrum 9010X Receiver
Dual 4S 5000 Packs
RC Carbon Gimbal for now
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|New Product||DJI WooKong-M Autopilot System for multirotors **Owners Thread**||DJI INNOVATIONS||Multirotor Drone Electronics||20298||Mar 20, 2017 03:26 AM|
|Discussion||DJI - WooKong eStab for Scale||sidneyw||Scale Helicopters||97||Dec 30, 2012 10:48 AM|
|Cool||Karbonic-XXL 50CM DJI WooKong-M frame||superdave42||Multirotor Drone Talk||12||Mar 09, 2012 10:01 AM|