How to get outer profile of a delta wing
I,ve made a few delta(triangle) wings cut out of polistyrene.I use a hot wire connected to a nail on the one side and I pull it through by hand on the other side.
The problem I have is that on the side nearest to the nailv is forever melting no matter what the temp is set to or else the tip of the wing is so thin.
I want to get the same profile as the inner and just reduce it in size to the size I want.
I was thinking of making a photo copy of the profile and reuce it to the size I want.
Any other ideas?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||How to get from flying mSR to Blade SR Huey?||impostor||Beginner Training Area (Heli-Electric)||6||Sep 08, 2011 12:04 AM|
|Discussion||Scratch built Delta wing Profile?||The_RattleSnake||High Performance||0||Aug 10, 2011 08:44 AM|
|Video||micro super cub for air hogs + delta wing test and profile gee bee r3 test||dr rc||Electric Plane Talk||0||Jun 24, 2011 05:26 PM|
|For Sale||Profile delta type wing with servos||the_only_kris_20||Aircraft - Electric - Airplanes (FS/W)||1||Apr 29, 2008 03:00 PM|
|How to get CG for a delta wing? (Mirage)||GregG||Power Systems||12||Dec 23, 2001 01:29 AM|