Thread Tools
Old Sep 10, 2011, 05:32 PM
needforink is offline
Find More Posts by needforink
Registered User
Help!

Belt problems wasp v3


Hi all
I have a recurring problem with the belt on my wasp v3 6 ch.Every time I power up the main rotor the belt develops a twist? I have straightened the belt and tried tightening it up from the boon but it still happens everytime I run it and its driving me nuts!! can anyone PLEASE HELP? thanks Rob
Sign up now
to remove ads between posts
Old Sep 10, 2011, 08:16 PM
Druss is offline
Find More Posts by Druss
Registered User
How does it twist? while i don't have that heli the only way I know for a belt to twist is if the entire boom rototes around. Is the boom slipping? to make the boom tighter in the boom blocks try putting some take around the boom then putting it back in the boom blocks.
Old Sep 11, 2011, 09:12 AM
needforink is offline
Find More Posts by needforink
Registered User
difficult to explain maybe I coud upload a vid to show whats going on but its all tight and in place and I can straighten the belt but soon as I put any power through it it twists again and makes the rotors judder Im fearing it may snap as well are they hard to replace what is the procedure for replacement maybe I need to take it apart to try find out whats happening?
Old Sep 11, 2011, 10:47 AM
Druss is offline
Find More Posts by Druss
Registered User
How do you know the belt is straight to begin with and that it's twisting?
Old Sep 11, 2011, 10:48 AM
Balr14 is offline
Find More Posts by Balr14
Cranky old fart
Balr14's Avatar
Well, a belt that's attached to rollers on both ends can't twist. It can snag, bind or jump the roller, but it can't twist. You have something else going on. The tail boom doesn't hold very well on that heli and the tail roller housing is crappy.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Build Log My First CP Heli: WASP V3 by Skyartec bobepine Micro Helis 89 Dec 12, 2013 12:24 PM
Help! Wasp V3 Setup problem ingleburn Skyartec 7 Sep 12, 2011 12:49 AM
Question Will Wasp V4/Belt 250 parts fit on Wasp V3? cfanto Skyartec 8 Mar 24, 2010 05:02 PM
Discussion Belt CP or Wasp V3? sketchanderase Mini Helis 0 Nov 13, 2008 09:11 PM
Discussion honey bee fp or skyartec wasp v3 fp with brushless and belt drive quadracer111 Micro Helis 3 Mar 17, 2008 05:10 AM