Help?! Just purchased a Feral-Beast and it just flashes red? - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Sep 09, 2011, 07:55 AM
Registered User

Help?! Just purchased a Feral-Beast and it just flashes red?

Have just purchased this Beast ..

Read the instructions as best as I can, understood the throttles etc.. turn the Remote on first, then the helicopter, all the helicopter does is flash red, and no signal seems to change hand between the 2?

Any advice?!?!?!

Thank you
Sign up now
to remove ads between posts
Sep 09, 2011, 11:08 AM
Registered User
make sure left stick is all the way down, possibly the trim (small tab to the right of stick) as well.
Sep 09, 2011, 01:04 PM
Registered User
Have tried that, it is like it does not connect with the remote, just keeps flashing red
Sep 09, 2011, 01:56 PM
Registered User
Is that the exact version you bought? the 72mhz version with the long antenna? If so check to ensure the crystals are seated properly. Take them out and push them back in firmly.

Sorry, now i'm confused, the description says 2.4ghz but the picture shows 72mhz...

If it is 2.4ghz there is usually a binding procedure.... are there any switches (besides on/off) on the remote? can you push down (depress) either of the sticks?
Sep 26, 2014, 05:43 PM


most of the cheaper helicopters bind the same.
transmitter on model on , throttle to full for a second or two ,then back to zero.
it will hopefully be bound !

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Feral Beast Apache spares UK DaveBee Electric Heli Talk 4 May 24, 2011 06:01 AM
Help! Feral Beast Apache Throttle Problem shotdown85 Coaxial Helicopters 5 Jun 02, 2009 02:45 PM
Discussion 4ch Feral Beast 4ch Heli For sale rccary Coaxial Helicopters 0 Feb 18, 2008 07:16 PM
Discussion GT3/Feral Beast Apachie lipo / charger question. 300s Micro Helis 0 Jul 08, 2007 04:21 PM
Phoenix 10 just flashes? HELP! Silverstreak328 Micro Helis 5 Aug 19, 2004 05:32 PM