jet screamer 1400 shaft removal. - RC Groups
Thread Tools
Sep 08, 2011, 01:33 AM
Registered User

jet screamer 1400 shaft removal.

I need help from someone who had replaced or disassembled Jet Screamer 1400 70mm version.

I need to remove the original shaft off the bell. So far, both set screws are out.
Shaft will not even move at all. I tried heating the bell, but too much heat may cause problem with magnets, so couldn't heat too much.

I've tried hitting the shaft from outside without luck. Don't want to damage the bell as it needs new shaft going in.

Any idea on how to remove the shaft?
Sign up now
to remove ads between posts
Sep 08, 2011, 07:59 AM
Registered User
This should help you out:
Sep 08, 2011, 08:55 AM
jackerbes's Avatar
Take a longer tubular object, I use deep socket wrench for example, that is large enough to just clear the shaft and put it up inside the housing. That concentrates the pressing forces on the area around the shaft.

Then use a vise, press or even a hammer to force the shaft down through the snug fitting hole. If you use a hammer, put a softer piece of metal on the end of the shaft and strike that, don't strike the shaft directly.

And make sure the housing is not resting on the ends of the magnets or it might break the magnets loose from the housing.


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold NIB Jet Screamer 1400 (90mm fans) flanker Aircraft - Electric - Jets (FS/W) 2 May 27, 2010 01:57 PM
Sold 70 mm jet screamer 1400 and wm 400 fan $60 shipped java8297 Aircraft - Electric - Jets (FS/W) 2 Nov 01, 2009 11:58 PM
Wanted Jet Screamer 1400 wanted! craigmel Aircraft - Electric - Power Systems (FS/W) 0 Feb 25, 2009 07:30 PM
For Sale Jet Screamer 1400 + HET 6904 70mm fan Dan Halverson Aircraft - Electric - Power Systems (FS/W) 5 Dec 15, 2008 10:52 PM
Wanted jet screamer 1400 hondaboy92hatch Aircraft - Electric - Power Systems (FS/W) 1 Aug 24, 2008 10:45 AM