Setting up flaps on DX8/6210 Combo?
I am currently putting together an EFlite Beaver and am up to the flap set up stage.
My transmitter is a DX8 and the receiver is an AR6210 6 channel. The flap servo's are going in to a Y cable and I have either Gear or Aux1 to choose from in the receiver.
No matter what I seem to do I don't seem to be able to get the flaps to do anything. Can anybody shed some light on whether I should have the plug in Gear or Servo and what setting I should be using for wing type on the DX8?
I have googled for an answer to this and don't seem to be able to come up with a solution.
Any help would be greatly appreciated.
Just in case you're not aware, you get a specific flaps mix with built-in elevator mixing, which you will need to set up to avoid the model shooting skywards when you hit the flaps switch. The other good news is that you can control the transition speed so that the flaps move slowly rather than all in an instant.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Spektrum DX-7...setting up flaps||Captain Ron||Radios||19||Oct 12, 2011 10:05 PM|
|Discussion||Setting up Dx8 and Dx7 in Trainer Mode||nking||Radios||3||Jul 26, 2011 02:25 AM|
|Question||Setting up 'Flaps' on DX6i and AR6100e||Flypoppa||Radios||2||Jun 27, 2011 02:29 AM|
|Discussion||help setting up flaps||JBuck||3D Flying||0||Apr 22, 2011 08:05 PM|
|FVK Silent Dream: Setting up flaps/throttle on a Futaba 9C transmitter||PDX Slope Pilot||Electric Sailplanes||5||Sep 22, 2003 11:39 AM|