>>Would adjusting the yaw pot on my KK controller board help me fix torque issues?<<
Let's focus on what the Yaw pot does on a KK board. The yaw pot normally adjust the gain of the yaw gyro compensation. That is the higher you turn the pot the more the servo will tilt the motor to compensate for the yaw motion.
Second function of the yaw pot is to calibrate the speed controllers. You turn the yaw pot minimum and throttle stick at full and power on the controller board to calibrate the high end of the speed controllers.
>>I only ask because tilting my rear motor to the right to compensate for the counter clockwise movement is not working.<<
Ok, try to look at your tricopter from the rear towards the front and try to understand this. You can figure it out yourself. Now if top of the motor is leaning right which way is the propeller blowing air? The propeller is blowing air to the bottom to lift the tricopter and the propeller is blowing air to the left. Correct? Can you see it? Now if you look at your tricopter from the top. If something is pushing the tail motor to the right (that will happen when the propeller blows air to the left the tail will go right) which way does the tricopter spins? Counter clockwise!!!!!! So of course tilting the motor to the right will not help your counter clockwise spin! It is helping the counter clockwise spin!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Yaw gyro KK board not responding||Menno||Multirotor Drone Talk||10||Nov 26, 2013 09:58 AM|
|Discussion||KK Controller Board and Counter Rotating Motors||rtbchris||Multirotor Drone Talk||18||Aug 29, 2011 03:43 AM|
|Discussion||Can a KK Controller Board Ruin My ESCs?||rtbchris||Multirotor Drone Talk||8||Aug 25, 2011 01:11 AM|
|Discussion||Devices That Work with KK Controller Board?||rtbchris||Multirotor Drone Talk||10||Aug 21, 2011 04:41 PM|
|Discussion||KK Controller Board and Li-Po Batteries||rtbchris||Multirotor Drone Talk||2||Aug 15, 2011 02:03 PM|