pictures of the wind tunnel - RC Groups
Thread Tools
This thread is privately moderated by yomgui, who may elect to delete unwanted replies.
Aug 27, 2011, 09:43 AM
Suspended Account

pictures of the wind tunnel

Entrance cone of the wind tunnel:

Even the belt was not enough to curve the four parts in the right position!
The curve is simply parabolic function.
The entrance cone is kind of too short, but I needed place…

Inner side surface is not perfect.

Build up with some improvisations.

The “honeycomb” (balsa) was a bit complicated to make and is still a problem, slowing down the airflow but much better for steadiness (believe or not!).
The anemometer used as reference for speed measurement:

Speed is only around 53 km/h in the test room, limited by the low pitch of the wind tunnel propeller(s) and the poor performance of the motor that spinning it.

The entrance cone should be easy to remove and replace.

The door of the test room:

USB cable:

This is just to prevent the door from falling when speed comes back to zero:

Pitot tube installed for “velocity distribution” tests:

From upside:

Exit cone from the inside:

Wind tunnel motor speed control:

Exit cone:

2800 tr/min, rated 900 W dead lawn mower motor and 2 graupner 20x12 props (needs 4 blades 20x20 and a good motor).

Sign up now
to remove ads between posts

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Wind Tunnel Smoke zagisrule! Power Systems 23 Feb 06, 2015 01:28 AM
Discussion Wind Tunnel F/S, not mine, but someone may have a use Stalled Modeling Science 1 Dec 30, 2011 12:35 AM
Discussion Propeller wind tunnel tests yomgui Power Systems 35 Jul 30, 2011 06:35 PM
who's got wind tunnel pics? Tim Green Electric Plane Talk 0 Feb 13, 2003 12:34 AM
sources of wind tunnel pics Tim Green Modeling Science 0 Feb 10, 2003 08:29 PM