Thread Tools
Old Aug 09, 2011, 08:21 AM
PACubFlyer103 is offline
Find More Posts by PACubFlyer103
Ron Lauser
PACubFlyer103's Avatar
Discussion

T-28 Trojan UM - Motor stuck on full


I took my recently purchased (not new) T-28 Ultra Micro out for a few flights before work this morning. After a crash which knocked the battery free of the plane, I plugged the battery back in and now the motor rus at full speed. Moving the throttle stick on the transmitter has no effect. The other controls (rudder, etc)still respond to the transmitter sticks. Turning off the transmitter has no effect. Motor rus at full until I disconnect the battery.

I really didn't think the crash was hard enough to break anything.

Has anyone ever seen this problem? Do you think I have a bad receiver/esc?

Thanks.
Sign up now
to remove ads between posts
Old Aug 09, 2011, 09:06 AM
buratino is offline
Find More Posts by buratino
Registered User
When I connected the motor to wrong port (+ and signal i/o + and -) it also give me full speed when I connected the battery. You may try to disconnect the motor and reconnect it or check the connector.
Old Aug 09, 2011, 11:58 AM
Chris_F is offline
Find More Posts by Chris_F
The new guy
Two additional things:

The throttle axis may be reversed (happened to me). The 6400 brick may have been programmed from brushed to brushless control.
Old Aug 09, 2011, 01:11 PM
village_idiot is offline
Find More Posts by village_idiot
Inciting Riots
village_idiot's Avatar
Could be a burned FET on the motor controller, I've seen the same with Plantraco.
Old Aug 09, 2011, 02:41 PM
PACubFlyer103 is offline
Find More Posts by PACubFlyer103
Ron Lauser
PACubFlyer103's Avatar
What is an FET?
Old Aug 09, 2011, 04:32 PM
village_idiot is offline
Find More Posts by village_idiot
Inciting Riots
village_idiot's Avatar
It is the output transistor that is used to turn the motor on and off, they usually fail by burning up and cracking the plastic case on the component so a visual check is normally all that is needed. Look for a small burned up chip on the receiver board.
Old Aug 09, 2011, 05:02 PM
PACubFlyer103 is offline
Find More Posts by PACubFlyer103
Ron Lauser
PACubFlyer103's Avatar
Thanks guys. The problem is now fixed. The brick must hae swithed to brushless control during the crash. I followed the procedure in the AR6400 manual to switch it to brushed control.

Thanks for the help.

Ron L. from Southeastern PA
Old Aug 15, 2011, 02:49 AM
Groovechampion is offline
Find More Posts by Groovechampion
Micro enthusiast
Groovechampion's Avatar

Micro T-28 Parkzone throttle full.


I was just reading this post, sometimes after Ive been over zealous with my UM T-28 and hit the ground a bit harder than normal, I find that the Motor wont work or if it does its stuck on full.... I found out that if I re-bind the bird she comes back to normal....


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold PZ UM T-28 Trojan Jbray Aircraft - Electric - Micro & Indoor Airplanes (FS/W) 2 Aug 08, 2011 07:22 PM
Sold Parkzone UM T-28 Trojan BNF Airplane + Extra Parts & Spare Airframe - $70 Shipped antmeeks Aircraft - Electric - Micro & Indoor Airplanes (FS/W) 3 Jul 14, 2011 02:11 PM
Sold Parkzone UM T-28 Trojan BNF tamiyafan1975 Aircraft - Electric - Micro & Indoor Airplanes (FS/W) 4 Jul 12, 2011 02:58 PM
Discussion ParkZone UM t-28 Trojan RTF on sale for $99 Aerosheik Hot Online Deals 0 Jun 03, 2011 03:40 PM
Discussion Trojan T-28 (UM) Motor Failure iCurtis Beginner Training Area (Aircraft-Electric) 3 May 16, 2011 08:41 PM