3DHS Buck Huck Motor Box replacement - RC Groups
Thread Tools
This thread is privately moderated by Chuck, who may elect to delete unwanted replies.
Aug 08, 2011, 05:06 PM
Balsa to the Wall
Chuck's Avatar

3DHS Buck Huck Motor Box replacement

Well, the second time I bashed the motorbox, I decided to try the motorbox replacement kit, and I was impressed by how easy and straightforward it was.

First off, save the balsa bits that broke off so you can put them back in place when you put the box in.
The tools I used were:
X Acto knife
diagonal cutters
mini needlenose pliers
micro bar clamps
wife's emery boards
Epoxy- 30 min and 6 min
thin and thick CA

You should have some scrap balsa in case you have to replace some balsa pieces.

Here's a pic of the plane with the front of the box removed.
Then with the rear of the box removed,
then, finally with the box completely out.

Use plenty of debonder to soften the CA and then gently pry the parts apart with your X Acto.
Use the diagonals to cut thru the thin parts of the ply so that you can take it out in small pieces.
DON'T FORCE ANYTHING, let the debonder do its job.
When you have it apart, cut the residual CA off of the parts in the plane so that the new box will fit.
Last edited by Chuck; Aug 08, 2011 at 05:45 PM.
Sign up now
to remove ads between posts
Aug 08, 2011, 05:20 PM
Balsa to the Wall
Chuck's Avatar
Now, we take the new box and assemble it completely outside the plane so that we know what goes where. IMPORTANT, make sure that you get the right and left sides positioned correctly and marked.

Here is a picture of the box parts laid out,
and then partially assembled.

You probably won't use all the parts in the kit.
Aug 08, 2011, 05:28 PM
Balsa to the Wall
Chuck's Avatar
Now, we start replacing the box. I didn't have to replace any formers or bulkheads, luckily.

The next pix show the progression of the replacement.
Aug 08, 2011, 05:33 PM
Balsa to the Wall
Chuck's Avatar
Almost finished, front of box clamped so Epoxy can cure.
Aug 08, 2011, 05:39 PM
Balsa to the Wall
Chuck's Avatar
Here is the motor mounted, then a pic of Jack with his new cowl and motorbox ready to huck.
Oct 27, 2011, 12:31 AM
3drcparts's Avatar
nice job, looks new again

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion 3DHS 48" EDGE 540 (1.5 Buck Huck) blucor basher 3D Flying 16168 Nov 16, 2017 07:34 PM
New Product 3DHS 41" Edge "$99 Buck Huck" Ducati Mechanic 3D Flying 17299 Mar 27, 2012 04:37 PM
Sold 3DHS 48" Edge Orange "Huck Buck" NIB 170.00 Shipped boatdoc Aircraft - Electric - Airplanes (FS/W) 5 Aug 03, 2011 07:53 PM
Sold 3dhs 41' edge buck huck bnf JBuck Aircraft - Electric - Airplanes (FS/W) 7 Jul 02, 2011 07:58 AM